Appliance Type: Microwave

This is an Microwave/ Oven combo this unit has power and all functions are working except for the microwave is not producing heat. The microwave has lights and the turntable motor turns as it should, we are not sure what is causing these issues now.

KITCHENAID MICROWAVE RAN DIAGNOSTICS ERROR F1 E5 SCREEN SAYS REPLACE MICROWAVE INVERTER. I REPLACED INVERTER AND MICROWAVE CONTINUES TO GIVE SAME ERROR CODE. I CHECKED SOME OTHER POSTS AND THEY INDICATED THAT HE APPLIANCE MANAGER IS THE CULPRIT. I REPLACED THE APPLIANCE MANAGER DIAGNOSTICS SAYS STILL SAME ISSUE F1 E5 CAN YOU TELL ME WHERE TO GO FROM HERE. I TRIED TO RESET ERROR BY GOING INTO DIAGNOSTICS OFF OFF START THEN 6 THEN 6 AGAIN THEN PUSH START AND THAT IS SUPPOSED TO RESET BUT ONLY BEEPS.
WHAT OTHER CHECKS CAN I DO.

FAN RUNS EVEN WHEN MICROWAVE IS OFF AND CODE 161. WHAT COULD IT BE ?

doesn’t turn on to cook but the timer stills counts down like its cooking.

My GE MICROWAVE bejv177zla suddenly stopped working. I’ve replaced the fuse and used electronic cleaner spray on the door locks the clock is out Could it be the thermal fuse on the magnetron?

When opening the door on the microwave when it is still running it flips the breaker. A friend told us last night that should not be happening. Solutions?

One of the shelf supports on my Amanda microwave partially melted. I found and purchased a replacement. How do I remove the old support. Can I pry it off with a screw driver? Will this damage the interior. The shelf support part number is 2080030.

My Samsung microwave is showing an e83 filter code how do I fix it?

Error code 1006 on Thermador

Thanks in advance

I need to remove and replace the control panel on my GE microwave model JVM6175EF1ES. I have the part

Hi my kitchenaid microwave went completely dead on me after the door mechanism got stuck. I was able to release it no problem and the door opens and closes perfectly but the unit is dead as can be. Checked the breaker and it’s A-Ok.

not heating

My microwave can not be used because of a code on the screen that says F9Q

My Microwave is in lock mode. How do I unlock it?
GE model number JNM7196SK1SS
manufactured December 2016

My microwave just stopped working in the middle of a heating cycle as I was opening the door. No power, no lights

I have a built in GE microwave and all the keys and settings work on control panel but when you push start it hums but does not come on.

My KitchenAid microwave convection oven turns on, lights up but carousel does not turn and food doesn’t cook. was working fine until i used what i thought was the timer for 60 minutes – turned out it was on for that length of time.

I inadvertently put the microwave on for an hour thinking it was on the timer. It is dead now. Any ideas?

No power on microwave. Found breaker tripped and it worked for a short time but now it’s out again and breaker is good. Model:JVM1740SP2SS

With the door open, the turntable runs. No heating. No magnetron. It also pauses now and then. I’m certain the control board is bad. The model is the one you mentioned above. I have priced a board. I will change it out. I have found I can buy either the control board itself or the entire assy.Question: is there any stored electrical charge? Capacitor, ect ect? Do I ground the board during change out?

Need to get handle off microwave door.

Hi My microwave is working except for the sensor options. When I press “potatoes” or “sensor reheat” and “start” it flashes ERROR. I tried resetting via fuse; no luck. Time for a new microwave?