Appliance Type: Microwave

I am coming in behind a technician that has been working on this for the past month. He changed the door switches out, no idea what else. All 4 switches test good. Call tech support and they said according to the service manual this model should only have three switches. But all four switches are wired up. I can’t find the service manual can you send it to me. Thanks

No power at all, already checked the fuse and it’s good.

This microwave keeps blowing fuses then it will make nothing appear in the display. It only blows the fuse when the heat kicks on. Any other functions doesnt have an issue, but using the heat will blow the fuse.

it seems that the microwave needs a new mag tube and diode.

Do you have the service manual for rvm5160dh1ww- is a hotpoint and for jvm7195df1bb- is a GE? The ge comes one but does not heat. How do I eliminate the control board from the magnetron and magnetron thermostat?

I Had a OL reading on a Cavity thermostat. Tech sheet said it was a single pole thermostat and that the contacts close at 158 degrees Fahrenheit. Now i thought this was a normally open thermostat then? totally confused me? Can you ellaborate with this. is that when they close after being heated up, or is this normally open? this is ona microwave btw which i thought would break the circuit.

DISPLAY IS NOT BRIGHT, ORDERED PART FROM BOSCH – PART IS UPDATED AND LOOKS A LITTLE DIFFERENT. RELAYS NOT EXACTLY ON THE RIGHT PLACES, BUT THE PROBLEM IS THAT ITS GIVING ERROR CODE E-01
CANT GET IT OUT OF THE SCREEN

Hello,

I have a KitchenAid Wall Microwave/Oven combo. Recently the the turntable stopped spinning. I checked the coupler and determined that it is not broken and suspect the issue is with the turntable motor (the turntable now spins freely, I don’t remember it doing that before). I need to know how to access the underside of the microwave (at least I think I need to) in order to replace the turntable. I’ve looked online and can’t find any videos or instruction on how to do this. Can you please help me with this issue or provide direction to reference materials to complete this task?

Thank you,
Jeff Wessling

This is an oven/microwave combo. Oven works fine and microwave works good except for it will not run longer than 1 minute. At that point, in the oven control board screen it will give an error code of F3E2. The microwave board doesn’t display this code. The oven sensors check fine as well as the oven works great! Not sure what this could be causing this as all works well except for the 1 minute time issue. Set for 3 minutes will cut off completely at 2 minutes. Any time frame will do the same.you can also start the microwave back up instantly and it will run for 1 minute. Any help would be great!!!

Unit powers on without issue. I had set the timer on the touchpad (for testing purposes) by pressing 1 0 0 0 ( for ten minutes ) and then hit “start”. After I hit the START button on the touchpad, the timer was counting down without issue but the microwave was not on or activated. I could not hear the motor or the fan or magnetron or anything.
Could there be a bad switch on the board inside ?

Without disassembling the over the range microwave. When it operates but will not cook is there a way to determine if its the transformer or even capacitor and Not the magnetron and diode that need to be replaced that you guys state in your repair videos for microwave not heating???

Hi,
The microwave blowing fuse, I was testing the switches I found the normally closed one is no good, I changed the switch.
The microwave worked perfectly at that time, now when opened the door again, the fuse blowed up again. Now I need help on what I should do and what is the problem.
Thank you.