Brand: Fisher & Paykel

Parker &Fisher, not spinning motor getting hot? Is there a way to know transmission is bad? How do you put this machine in diagnostic mode?

Hey Guys.
I am attempting to replace the baring on my Fisher & Paykel Drying.
I managed to remove the baring. However, the washer (SHIELD DUCT INLET) on the backside, can only be reached by removing the entire
outer casing.
The shell appears to be attached at the bottom by the feet.
I can’t figure out the mechanics of how the feet are attached.
Hope you can help.

Carl (504) 460-7242

What would cause this?

Washer isn’t going into spin cycle?

Not very knowledgeable on these yet and am wondering if it’s a bearing like many other brands? Has a slight rubbing noise as well, am thinking it may be more than one thing but not sure. Any help would be great.

I am working on a Fisher Paykel Dishwasher – Double Draw unit model# DD602I
This unit’s draws do not have the tabs on the side of the draw to “push” and remove draw to access the overflow sensor and/or grab the service tech sheet in the back inside of the unit.
Looking for the tech sheet for F/P DD602I ? I have the one for the DD603? If they are the same I will use it, but I believe they are different.

My Fisher Paykel dryer is not heating intermittently.

I am having a problem with a Fisher & Paykel Washer.

The door on my Fisher & Paykel refrigerator will not open.

My Whirlpool refrigerator seems to be off balance.

Trouble pulling the doors out, Clicking or scraping sound when opening the drawers.

I narrowed this down to an inverter board but now can’t get the model breakdown to come up. Any chance you guys can send it over to me, or the board part number?

I have a dish drawer that overfills.

My Fisher & Paykel dryer is making loud high pitched noises

My Fisher & Paykel washer is leaking water out of the back.

This is a double dish drawer. The bottom quit draining after another company tried to fix it. The top continued to work but then it would power up; lock; and after pressing start about 10 seconds would power off. Any Ideas?

Unit beeps then Error codes are displayed, display is blank, powers up but will not run, Fault code 151.

I get a lid lock error in diagnostics mode. However it stopped mid cycle. I did replace the lid lock, still no function. just beeping. I ordered the sensor control board but before I install it would like to know if it could be something else

Unit is running constantly, not turning off by itself. It’s also leaking water and tripping the flood switch. I think it needs link kits for both drawers, and an upper drawer seal to solve the leaking. I cleaned a lot of debris from the sump areas and it completed a cycle and shut off by itself. Could you guys help me out with parts availability and numbers?

Can you tell me what could be causing this issue on a Fisher & Paykel Washer? It is having these problems: Will not start.

Hello I have a question on a Fisher & Paykel Dryer. I’m noticing these issues: Leaking water

Display is blank, no voltage to the motor, error codes are displayed, Fault code 151.

I purchased a Fisher & Paykel fridge some years ago and now the handle on the fridge has broken off. The top of the handle is a hook that goes into the door and the bottom looks like it had a lug into the door that has sheared.