0 votes
1k views

the refrigerator side stays at the set temperature, but the freezer side doesn’t go lower then 41 degrees I have the setting at 5 degrees.

  • flukedup asked 2 years ago
  • last active 2 years ago
0 votes
965 views

the programming starts normally, water and washing works, when it is on the programming to drain the water the pump does not turn off and shows error I30, I have already replaced the board and the same defect continues

0 votes
745 views

Need a service manual & wiring diagram along with error codes .
Thanks

0 votes
1k views

When cycle start water fills up and drain as intended but tub not turning.

  • brepkemp asked 3 years ago
  • last active 3 years ago
0 votes
984 views

Frigidaire model#GLFH21F8HWE

0 votes
949 views

This is is a Frigidaire oven this the door lock error? Which board controls it if it is,? How can I check this issue?
I need a service manual and tech sheet and your expert advice.

  • Pancakes asked 3 years ago
  • last active 3 years ago
1 vote
1k views

Water is splashing through the vent hole in the seal at the left side of the bottom. I replaced the seal. That didn’t stop the leak.
I tilted the dishwasher toward the back and that didn’t stop the leak.
What is causing this? Is this an issue with this model?
What is the solution?

  • Pancakes asked 4 years ago
  • last active 4 years ago
0 votes
1k views

Unit has no power. What do I look for and if it is the timer how do I test the timer.

1 vote
1k views

The washer will try to shift to agitate but seems to get stuck.
It will not let me enter diagnostics so I can check the error code. What is the trick?
Is this the actuator or the motor?
Does this motor have a built in clutch or can it be charged? This is a Frigidaire

  • Pancakes asked 4 years ago
  • last active 4 years ago
0 votes
1k views

I changed the infinite switch and it did the same thing.
If I begin on low it will heat and cut off but will not come back on even after 10 minutes. If I turn it off and then back on it repeats the same cycle. It will stay on high. If I set it on 3 or 4 it does the same.
Can this be the sensor in the burner?
How does it work?
It doesn’t matter if I use the single or dual settings.

  • Pancakes asked 4 years ago
  • last active 4 years ago
0 votes
1k views

All the dryer does is flash pause. It won’t even let me cancel. Therefore I can’t retrieve errors or run the service mode. The door switch tests good.
Can a bad door switch or thermal cut off or another bad part forbid me to extract the codes or even enter diagnostics?

  • Pancakes asked 4 years ago
  • last active 4 years ago
1 vote
2k views

I have changed the water valve and it still freezes up. I have ran the diagnostics and the ice room temperature sensor is good, showing 3 degrees. The icemaker test is good. When I de ice the fill tube it will work and make ice for less than a day then refreeze.
It has done this 3 times.

The first time I found it froze and tried to run the diagnostics it would not work until I unplugged it and restarted it then it was ok.
What is causing this problem. The FILTER is good and so is the water pressure.
Is there a service bulletin on this or some other issue?
Or what?

  • Pancakes asked 4 years ago
  • last active 4 years ago
Showing 31 - 60 of 395 results