Brand: Frigidaire

Frigidaire dishwasher bottom arm works great upper arm does not turn because the water does not go all the way to the top of the tube that runs up the side and to the top of the dishwasher and then shoots down to the upper wash arm . I have added more water and that does not help . If I stop the washer and restart it in a few seconds the water will start then flowing strong to the upper rack threw the tube . When this happens the lower arm them gets no water to it . I did take the motor out and found some glass in the motor wheel , removed the glass and reinstalled the motor but that did not help the problem. The motor runs and seems to be running fine could the motor not be running as fast as it should and be the problem ? Only thing I can think is maybe a motor problem , the motor does seem to be running ok .

when we try to get ice or water out of the unit , it will not stop coming out

Hi, I wanted to find out how to replace the element in my oven? It cracked and broke in half while I was using it and my neighbor said I could probably handle replacing it myself. Would you advise this? I’m not sure if it’s something I could do or not. Any help would be appreciated!

My front load washer had been working properly, suddenly it stopped working at the beginning of a load. When I press any buttom it does not make anything. When I turn the knob, the little screen on the washer only shows parts of numbers. I tried to get the error code but it does not respond either. Thanks

My washer has been making a noise and finally stopped spinning. When we took back off the belt was off and the clutch was off. What do I need to do?

My dishwasher will fill with water and it drains fine but it won’t start the wash cycle.I have checked and the circulation motor and pump are free, float switch is working I also checked that everything is getting power. New circuit board, both pumps. I would appreciate any help Ken

it runs, no cool air, the fan works transferring air to the fresh food

The thermostat seem to check out good.The fans in the fridge and freezer are blowing I cannot tell if the compressor goes on or not. What might I check to see if one of the other switches is bad. I don’t know if it is whirlpool or frigidaire. It is a sears coldspot.

Refererigerator not cooling replaced main board and defrost terminator worked about 7 days and stopped cooling again any ideas?

I’m hoping one of the techs there can help me figure out what part I need to replace. I’ve checked the line and the pump for any debris but didn’t see anything. Just sounds like the pump isn’t actually working correctly. Is it more than one assembly I’ll need to replace? A video would be great as well if you can find one for me.

how do I access the switches

I’m hoping you can determine if this is my ignitor failing, possibly the thermostat, or something else altogether. Most times it heats fine, bakes correctly. Other times it doesn’t seem to hit temperature, or falls short. Looking for some confirmation before replacing parts. Thanks.

Can somebody get me the part number for gas coils for my dryer? It isn’t heating up anymore. My son is going to come fix this for me and I can’t find the number. I keep telling him it’s an easy fix and if I can get him here I want to make sure I have the part he needs to get it working again. Can’t have him yelling at me for not at least doing that. And thank you.

The entire touch pad works except for Bake, Broil, and convection. All the digits and timers clock keep warm, pizza, the rest of the key pad functions. Tried to reset by unplugging. Didn’t work. Oven comes on by using the pizza function. Top burners work as well. Why only a few not work?

Our dishwasher quit working and is flashing an ER code. How do we diagnose what it needs?

My vent microwave exhaust fan does not work on the low speed but works fine on the high speed.
I have tried unplugging, waiting and plugging back in with no effect.
All other buttons on the touch pad seem to work just fine.
Any diagnosis tips or is there an obvious solution?

The outer door panel is broken and prevents the door from closing properly. Since the outside panel was broken, it came off easily. Now I am trying to put it back on. What is the best way to put the door back on? It appears the door needs to be disassembled so it will fit around the door hinge.

Thanks

I have a frigidaire dryer that no longer heats, my clothes are still wet inside after two cycles. I had a hard time finding the correct replacement part online and there wasn’t a video I could find for my model. Hoping someone can help!

My washer wasn’t spinning so I took off the cover and found a broken belt down underneath. I couldn’t find a video with the part number or model and need a little help in figuring out how to install the new one.

I’m looking for a little direction on what might be happening to my fridge. There’s a lot of frost building up in the back of the freezer on that panel and it’s starting to not cool. It’s done this before and then started working again. The frost diminished and all seemed fine. Now it’s happening again, and it seems to be worse this time. From the videos I watched it seems like it could be a few things. I checked the heater and board last time and again today, they are good. Any way to help narrow this down for me? I’d really appreciate it.

THANKS FOR YOUR HELP on our Frigidaire dishwasher. WE ALREADY FORKED OUT $120 AND REPLACE THE CONTROL BOARD AND THE ERROR CODE IS STILL FLASHING. I GUESS WE NEED TO WORK ON THE TOUCH PANEL OR CONSOLE, HUH? That should do it, right? Is there a video showing how to do this?

CHRIS HIGGINBOTHAM

When start button is pushed timer lights up and counts down but nothing else goes on. Do I need a new control panel?

dryer won’t start. turn drum by hand & then push start button it will start. let go of start button it will stop.