1 vote
2k views

lid will not close

1 vote
2k views

The morning after an electrical storm the temperature control display shows “88 88” with the second 88 blinking and the controls do not work.
The refrigerator and freezer seem to be working but I have no control over the temperature. Is there a way (sequence) to reset the display or
have I lost a:
Main Circuit Board
Power Control Board
LED Light Board

  • Guest asked 6 years ago
  • last active 6 years ago
1 vote
1k views

Customer had all burners on at one time then everything shut down And now it will not heat oven works fine user interface for the controls for the cooktop function but no heating And I do not have a service manual or a wiring diagram For this unit had to use norge because it would not let me select GE or General Electric the site would not allow it and it would not find it I know that it is in there because it has let me select that before it would not do it this time but it is a GE range

  • dwoods asked 4 years ago
  • last active 4 years ago
1 vote
2k views

NOT HEATING ANY AREA (OVEN OR BURNERS)

  • triadapp asked 7 years ago
  • last active 7 years ago
1 vote
2k views

it seems that the microwave needs a new mag tube and diode.

  • Guest asked 7 years ago
  • last active 7 years ago
1 vote
3k views

IS THERE A TECH SHEET HIDDEN SOMEWHERE ON THIS UNIT, IF NOT CAN YOU GET ME ONE? i HAVE AN ICEMAKER NOT WORKING.

  • Guest asked 7 years ago
  • last active 7 years ago
1 vote
2k views

GRIDDLE IGNITER WONT LIGHT
REPLACED IGNITER AND SWITCH

STILL – IGNITER DOESNT GET 120 BETWEEN 2 WIRES

WHAT TO REPLACE NEXT?

  • Guest asked 6 years ago
  • last active 6 years ago
1 vote
645 views

hello, Have a side by side refrigerator and the fresh food section is getting too cold. Freezer seems ok.

1 vote
3k views

I replaced the clutch and coupler on this washer, and now I’m getting a grinding noise before the spin cycle starts.

  • S&E Appliance Repair asked 10 years ago
  • last active 10 years ago
1 vote
2k views

I was just wondering if you could help me out. I’m trying to determine if the gas sprinkles are bad on my dryer. How do I test them?

  • Guest asked 7 years ago
  • last active 7 years ago
1 vote
2k views

Gentlemen, could you provide me with a tech sheet or service manual for this g, e. Refrigerator.
Evaporator is frozen up unit does not defrost. I suspect defrost control issue. Defrost heaters check good with the ohm meter, defrost thermostat checks good. I noticed the thermistor has been replaced. If you could pass any service information to me it would be a great help and greatly appreciated.thank you very much.

  • Guest asked 6 years ago
  • last active 6 years ago
1 vote
2k views

freezer staying at 26 deg. fresh food at 34 deg. replaced main control board after finding only 3 volts d.c. on the inverter input from main control board.

  • Guest asked 6 years ago
  • last active 6 years ago
1 vote
2k views

This GE monogram dryer is a Challenge to disassemble. Please advise do you have a sheet or a video

1 vote
934 views

I replaced the whole timer because the thermostat was damaged but now even with new timer including mother board and thermostat lights are flickering and timer is making a ticking sound and it doesn’t start

  • Guest asked 4 years ago
  • last active 4 years ago
1 vote
2k views

Machine fills but won’t agitate or spin. Digital display seems to be working o.k. It’s displaying times for cycles and no dimming of segments. Seems to be responding.

  • Guest asked 8 years ago
  • last active 8 years ago
1 vote
2k views

i hope I’m not going to be charged twice for the same question. The control board, defrost themostat and heater have been replaced. That leaves the thermistor not thermostat!
how do you check the thermistor (located left bottom of the evaporator cover) and is there an easy way to replace it.
the tech sheet does not go into this….in fact i found the color wiring different on the model I’m working on from the tech sheet (you gave me).

  • Guest asked 5 years ago
  • last active 5 years ago
1 vote
1k views

Eoc is blank. Vac good.

  • Guest asked 4 years ago
  • last active 4 years ago
1 vote
1k views

A while back the dishwasher would not start. The START button would flash and the indicator light flashes amber. It also beeps three times waits for a while and beeps three more times. This repeats over and over.

  • Guest asked 4 years ago
  • last active 4 years ago
1 vote
2k views

Is there a way to run a diagnostic test on this unit? The Tech sheet is very basic wiring diagram only. I need to verify if I am on the right track.

  • Guest asked 7 years ago
  • last active 7 years ago
1 vote
2k views

Hello Appliance Techs. Thank you in advance for your help.
I have not checked this unit yet, however, I know it is not cooling and everything in the freezer is frozen up. customer said evaporator fan is not running, water is dripping from top of the freezer. he said three months ago he had the defrost heater and defrost thermostat changed. do you have a service manual on this model.

  • Guest asked 7 years ago
  • last active 7 years ago
1 vote
2k views

The high limit right thermostat on this unit which would cut power to the motor located on the right side of the heating element , when this goes out what usually is suspected or root cause of that?

  • Guest asked 6 years ago
  • last active 6 years ago
1 vote
1k views

Hello, I am working on a french door GE refrigerator that cannot hold consistent temps in the freezer. The proof of this is in the ice tray. My customer’s ice seems to melt together into one big ice block and then re-freeze its self. There is also a large amount of frost on the food inside of the freezer.

(Also GE will not appear in the brand section of the question format page so I selected Norge since it was the 1st thing to pop up)

  • Guest asked 5 years ago
  • last active 5 years ago
1 vote
1k views

The clothes are coming out wet. At times it is not spinning at all.

  • Guest asked 4 years ago
  • last active 4 years ago
1 vote
2k views

the evaporator and condenser fans are running but the compressor will not run

  • Guest asked 8 years ago
  • last active 8 years ago
1 vote
2k views

How do I get the tub out of this washer

1 vote
2k views

HI DO YOU HAVE ANY VIDEOS ON HOW TO CHANGE THE TRANSMISSION ON THIS UNIT

  • Guest asked 8 years ago
  • last active 8 years ago
1 vote
2k views

A customer calls me up and tells me that her fridge does not work. The temperature is dropping in both the freezer and fridge, but the light is on… nothing else is working

  • Guest asked 7 years ago
  • last active 7 years ago
Showing 31 - 60 of 2k results