Brand: Whirlpool

How do I gain access to springs.

One door spring broke, should I replace both?
Access to replace springs. Video etc.
Do I have to watch out for fragile ribbon cable on top panel that can crack.

My Whirlpool washer is making an odd grinding noise.

Hi Folks,
The complaint on this unit is it is not cooling up to par! This unit has an inverter. According to the home owner the condenser has never been cleaned. Clean the condenser and it seemed to lower the temperature. But the inverter continued to beep. It was an inconsistence pattern of on & off and beeping. Not that familiar with inventers and any information will be greatly appreciated.

Thank you,

Jan
Barney’s Appliance
Palm Bay, FL

Can you get me a tech sheet for this unit. It is frosted up and I want to be able to do a forced defrost to check and see if jazz board is bad.

I cannot get any pads to work to enter code

Have unplugged unit for long periods 2 hours or more trying to reset any faults , see no faults , plugged back in this last time and lock out light came on . cannot clear it with end of cycle button , and will not let any buttons work . Display blank.
First few times I could unplug for about an hour and re connect and it would come on and dry to end of cycle . But while drying you could not pause or cancel drying. opening door would stop it however.
Is it interface board or control board ?
Thanks ;
Steve

Need service manual. Wonder if the freezer door SW controls the evaporator fan, light and something else?

Alex

Hello
We have an ice maker that was not harvesting
1) We have good water pressure and inlet valve was replaced .
2) Good freezer temperatures at + 1 degree with two different temperature test devices, ice cream solid.
3) 115 volts to the ice maker.
4) Replaced water filter
5) There is one switch in series that is closed and we have power to the ice maker.
6) Replaced two different new ice makers. Whirlpool tech. line wants us to put in a third new ice maker ? I don’t think this is our solution.

We can harvest manually one time and drops nice normal thickness cubes. Then will not harvest again. There are no service bulletins on this # WPW10469286 ice maker. Has anyone else had issues with these ice makers or have any suggestions before we put in a third ice maker ?

Thanks in advance

Do you have more videos available for this make and model for the washer machine?
If yes can you help me locate them? thank looking forwarding hearing your response.

There is a fuse link in behind the control board on this model that is blown. It resembles a diode a little. I cant find this part on any drawing and was wondering if you could help me with the part number to this fuse?

My Whirlpool washer is taking a long time to drain.

Dryer shuts off during high heat cycle after about 10 minutes, will run on low heat just fine. The dryer will start back up immediately after it shuts itself off. I replaced the motor in this dryer a little over a year ago, to me this sounds like a motor issue, but a little confused as to why it runs on the low temp cycle. Run with the vent off as well and same results as before. Any ideas or suggestions?

I am replacing the fresh food evaporator fan. I have watched your video on a similar model. This one is a 5 door and I’m not sure how to dismantle the draws and the center adapter between the two drawers.

I need technical manual specifically to run diagnostics and enter forced cooling.

We have came across many led issues on some of these refrigerators. Some lights won’t come on and when they are replaced they still won’t work even by replacing the boards as well. Please help