Brand: Whirlpool

RAN DIAGNOSTICS STARTED FILLING WENT ALL THE WAY TO C6 THEN WOULDN’T CONTINUE. I CANCELLED THE DIAGNOSTICS . ALSO WHEN DIVERTER VALVE IS ON HIGH PITCH NOISE WHEN I PULL THE WIRE IT STOPS IS THAT AN INDICATION THAT THE VALVE IS BAD.

Have a Whirlpool refrigerator Complaint, was leaking and small ice cubes and water in the fresh food floor.
The filter is in top right of fresh food compartment and the water lines in / out had molded plastic elbow fittings.
Both hoses cracked at the fittings . I replaced with new modified water lines ,now no leaks.
Cust said Icemaker still making very small cubes. { small icemaker mounts in freezer door ).
Anyone have a tech sheet on the icemaker and/or the manual for this refrigerator.

The dishwasher start/cancel button will press bit does not rest or start. I flipped the breaker for 10 minutes and it continued to do the same thing. I set it on 1 hr delay thinking maybe it would start. It locked up and no cycle buttons, delay options, or extras like heated dry will change now. I flipped the breaker and left it off the rest of the day. Last night (about 5 hrs later) it’s still flashing at me. I used it Saturday with no problems. Sunday it started with this mess. My 4 yr old did spill water on the counter and into the floor but the dishwasher is completely under the lip of the countertop. I doubt that enough water may have gotten on it but if it did then why did the other buttons work before flipping the breaker. The dishwasher is about 2.5-3 yrs. I use it 3-4 times per week. We’ve checked the filters and the ensured that the racks were in properly.

Timer motor will run to cool down part of cycle but won’t advance to off. The dryer ran from 10pm to 4am on cool down,

This is a French door model with ice/water in door. Controls on door. Upon arrival freezer was reading 4 and refrigerator 44. Controls were set for those settings. Do not see a damper assembly in fresh food section. Milk on door was frozen and , as well as other things. Looking at parts breakdown, only evaporator in freezer. So other than possibly thermistor or control board, what else is there thanks in advance.

I have a no cool refrigerator with the linear compressor can you give service information. I need any information you have on this unit. Never worked on one before.

We really can use some advice on a Whirlpool Cabrio washer # WTW6600SG2.
Customer complaint: Set on ‘NORMAL’ the unit will fill and run in the wash cycle for about 15 mins. pause, drops to 5 mins on display, drains and spins, end of cycle.
There are NO fault codes showing or saved.The control was replaced about 1.5 years ago. The unit ran fine after the board replacement.

We really can use some advice on a Whirlpool Cabrio washer # WTW6600SG2.
Customer complaint: Set on ‘NORMAL’ the unit will fill and run in the wash cycle for about 15 minutes. pause, drops to 5 minutes on display, drains and spins, end of cycle. There are NO fault codes showing or saved. The control was replaced about a year ago. The unit ran fine after the board replacement. This unit is located in a beach house and gets only a few months of use a year. Any help or advice would be greatly appreciated.

Compressor over heats and shuts down.

Will not make ice or dispense water.

My Whirlpool washer is displaying an error code

I went to a customers service call last week. They had a Whirlpool refrigerator and I’m checking it out and see this.
Serial tag says R134A, but on back I found sticker stating flammable refrigerant.
Can somebody explain this?

I have a code 09 when I run the diagnostics from the panel. My dryer will beep 3 three times when after pressing power and then pressing the start button. The drum light is not lit but tested good. I’m thinking it’s the door switch, correct?

Thank you!

Have a whirlpool refrigerator model GI6FARXXY07
the evap motor is not running.

oven wont work I reset house breaker it works when I try again I get error code feature not aavailable theni need to reset breaker and repeat steps