1
0

I replaced the main control board on this Kenmore dryer have 120 Going to the main control board no lights will not respond. I am considering that I might have a bad replacement main control board. do you have a schematic of a Kenmore or a whirlpool that you could tell me what voltages I should have going to the touch control display board. I have considered ordering the display touch pad board but would like to be sure before I order another board. Thank you for your help.

Model Number
11085876401
What have you tried so far?

replaced main control board measured voltages to the main control board. have checked connectors and wiring.

Request Resource Materials
Service diagnostics guide, Wiring diagram, Service bulletins, Service pointers, Any available materials
0
0

Hi. I show the main control as p# 8546219. IS this the board you installed? If so, and you have correct power to the main board and still no display it must be a faulty console/ U.I p # 8558758. Make sure you have 120v from hot to neutral and from hot to ground and 0 between neutral and ground. Check voltage at the board with the harness plugged in to make sure the voltage is not dropping out. I believe I found the tech sheet on this unit for you, or one very similar. It might have some voltage information to help you diagnose the correct part.

Showing 1 result
Your Answer

Please first to submit.