1
0

The appliance is only run approximately every 2 weeks as there are only 2 of us seniors in the household. I made all the selections as normal and selected the start, closed the door immediately, and shortly afterward the light started flashing and the beeper comes on. I have canceled the program multiple times and re-selected different programs to see if made any difference, but the same results occurred once the door was shut. I have check all the filters to ensure they are clean. I do not have an electrical schematic to see if there are any other permissive interlocks that could be holding the start initiation sequence out.

Model Number
PDT825SGJ0WW
Serial Number
ZG101588B
What have you tried so far?

As above, I have tried selecting different cycle selections to see if that made any difference, but it did not. Of course, I have done an internet search for the model number and troubleshoot, but there has not been much specific to the model.

Request Resource Materials
Service diagnostics guide, Wiring diagram
0
0

Hi. It sounds like you could have a door switch issue. Try pressing start with the door closed to be sure that does not change anything. I have attached the service manual for you. page 44 has diagnostic and error codes. Check to see what error code you have stored. I have seen a couple of these with bad door latches. I also attached repair videos for a similar model.

Showing 1 result
Your Answer

Please first to submit.