After beginning a cycle, the initial fill seems to take longer than normal. After a few moments, the unit begins to drain (without beginning to wash) and the “Smart Auto” light blinks.
I have cycled power to reset.
I have also already replaced the thermistor.
There is no water in the drip tray beneath the unit.
Model Number
DW80F600UTS
What have you tried so far?
I have cycled power to reset.
I have also already replaced the thermistor.
There is no water in the drip tray beneath the unit.
Request Resource Materials
Any available materials
- Guest asked 2 years ago
Hello
Go to page #45 in the service manual link below. Run the unit in the ( Service inspection mode ) This will pinpoint the specific issue and problem.
- AV Repair Help answered 2 years ago
-
It will not go into Inspection Mode.
-
Hello If you are going through the proper steps to enter the inspection mode. The only option is to replace the main PBA board if it will not let you enter the inspection mode.
-
Is that part #DD82-01139B?
-
How likely is the PBA board to fix the (initial) problem?
-
Its best that you call you local parts distributer to look up the part by the model & serial number. Some boards are serial number specific. You need to get the unit into the diagnostic mode to proceed forward. If you are entering the unit into the diagnostics mode correctly per the technician sheet, and it will not go into diagnostics mode you will need to start with the board.
- You must login to reply
Your Answer
Please login first to submit.
