0
0

I washer a large load today and now my washer will not spin. I seems to drain and fill ok and I can hear the motor when I put it on drain only setting. Can you please tell me ways to diagnos and fix the potential issues.

Thanks

Model Number
Atw4675yq
0
0

you will need to tip washer back and look underneath to see if the belt came off the cam pully there are 2 bolts that hold the protective cage in place remove those if belt off and not broken grasp center pully and see if it wiggles at all if it does you will need to replace it there is also an actuator locatted to the right of this pully that should be replaced at the same time 2 #2 phillips screw hold it in place the cam and pully are removed by removing the bottom nut and you need to release the push tabs locatted around the side of the cam so you can slide it done the shaft pay careful attention to cam and pully allignement actuator pin needs to line up with loop comming off side of cam hope this helps please write back if you see anything different from what i described and i can give you further assistance

0
0

you will need to tip washer back and look underneath to see if the belt came off the cam pully there are 2 bolts that hold the protective cage in place remove those if belt off and not broken grasp center pully and see if it wiggles at all if it does you will need to replace it there is also an actuator locatted to the right of this pully that should be replaced at the same time 2 #2 phillips screw hold it in place the cam and pully are removed by removing the bottom nut and you need to release the push tabs locatted around the side of the cam so you can slide it done the shaft pay careful attention to cam and pully allignement actuator pin needs to line up with loop comming off side of cam hope this helps please write back if you see anything different from what i described and i can give you further assistance

Showing 2 results
Your Answer

Please first to submit.