Washer initially presented water valve error so I replaced the water valve. Now it will fill but will not begin the cycle and does not present any error code.
Replaced water valves DC62-00214M and DC62-30314K
- Guest asked 4 years ago
Hello
Did you check that you had a good line voltage supply to the main board?
If you have proper 115 volts , I would recommend that you check the connector between the main board and the display board. You will need to check both the 5 and 12VDC power supplies, as well as the communication lines.
If you’re missing voltage at any of those points, you should try disconnecting the display board and performing the test again. This is to rule out whether the voltage is being loaded down.
See the complete service manual link below for all diagnostics.
- AV Repair Help answered 4 years ago
- You must login to reply
Please login first to submit.
