0 votes
3k views

Do you have more videos available for this make and model for the washer machine?
If yes can you help me locate them? thank looking forwarding hearing your response.

  • Guest asked 10 years ago
  • last active 10 years ago
0 votes
2k views

I have a Whirlpool washer from the early 80’s. My timer is not advancing. I want to know how to repair the original timer since Whirlpool does not make the part any more.

Or I wonder if there is a universal timer switch that will have the same power connections and mounting brackets? Either way let me know, we have been tapping on the dial for years now to get the dial to move to the next cycle. 

  • Ryan Jones asked 10 years ago
  • last active 10 years ago
0 votes
2k views

For the 30 inch wide refridge what is the model number of the repair kit for the drain tube 8 need? I see there are 2 kinds one for 30 inch and one for 33 and 36 inch wide models. Thanks bill

  • Bill harrigan asked 10 years ago
  • last active 10 years ago
0 votes
2k views

First, your subzero refrige coil repair video is great!!

We have two Subero units with the 2 compressors in a tray. The 700 series and also a 427 wine cooler with lower drawers.

These units are a nightmare to work on due to limited access.

Since there is nothing obvious about how one might be able to ever get to the back compressor for service, a video would be a huge help.

Are your tech people familiar with these units with the tray, and would they consider a video?

If not, is there anyone there who I could talk to on the phone about the tray style subzeros?

Thanks

  • ernie asked 10 years ago
  • last active 9 years ago
0 votes
3k views
0 votes
3k views

The washer is making a load noise like a train or plane loud taking off when it goes to final spin…
IF I run an empty load just the rinse spin it seems fine?
Doesnt seem to move on the floor or anything?

Is this a major repair? Clothes come out clean and well rung out… just really loud… If I spin the drum by hand moves smooth and no noise… and all the bar things inside are tight.

Its about 3 yrs old if that.

Thanks

  • Michelle Young asked 10 years ago
  • last active 10 years ago
0 votes
2k views

I am finding a bunch of water at the base of my refrigerator, it seems like I have a sheet of ice inside my freezer. My model number is GB2FHDXWS07, I had this fridge for a few years now, any help would be appreciated.

  • Eric Schmidt asked 10 years ago
  • last active 10 years ago
0 votes
2k views

I have a Maytag Fridge.
There is Ice Buildup in the bottom of the freezer

Model # MFX2570AEM0

What kind of part do i need for it and how much does it cost.

Thanks
Piyush Amin

  • Piyush Amin asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Good morning. I saw your video on how to release the drain catch on a Maytag front load washer, but my model does not have a separate front panel. Its one complete front door panel so I’m wondering how I can go about resolving this error. Please note that the door is also closed and I have been unable to open. Thanks.

  • Jessie Ruiz asked 10 years ago
  • last active 10 years ago
0 votes
2k views

The gravy went down the valve stem hole onto one of the Valve Switches. (The orange colored square switch can be seen looking down the valve stem). Could this short out that one valve switch and cause ALL burners to spark ignition when the unit is plugged in? If so, what is the procedure to disassemble the unit to replace that valve switch. Also, could that gravy spill have caused damage to the Spark Module? If so, where is it located on the model?

  • Bill Gale asked 10 years ago
  • last active 10 years ago
0 votes
3k views

My washer flashes the FH error code and It also has a little water leaking out of the front door. I’m not sure what I need, to fix this. I’ve found a lot of videos stating it’s different things.

  • Starla asked 10 years ago
  • last active 10 years ago
0 votes
2k views

just got this dishwasher new and door will not open

  • DOUG asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Hi, we have a 15 year old LG American style large fridge freezer that has stopped cooling/freezing overnight. There is power to the unit as the fridge light is working, however the freezer light is not. There is no sound coming from the compressor at all. I am just looking for some help with diagnosis, any information greatly received.
Thanks in advance

  • James kelly asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Thanks for video: https://www.youtube.com/watch?annotation_id=annotation_1962912323&feature=iv&src_vid=VSiLmJQmzEY&v=Tk24ISRzSRs

I’m ordering the part from your parts dept. right now. But I’m concerned that I won’t be able to properly clean out the drain.

The repair guy I hired 3 years ago, when we first had this problem simply removed the drain check valve (grommet) – and put nothing in its place. Well now my freezer’s all iced up on the bottom and the drain must have clogged again.

I will thaw it out and shoot hot water in there, but I’m concerned that I won’t be able to properly clean the drain. Should I snake a wire up from the back (where the grommet used to be)?

I haven’t taken the freezer apart myself – so maybe there’s a way for me to see the drain and clean it from the freezer compartment. But from the video, I didn’t really see that.

Any advice? I would really appreciate it!!
Jack

  • Jack Derrico asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Normal button blinks and the other buttons are inoperable. The dishwasher does not work.

  • al gaber asked 10 years ago
  • last active 10 years ago
0 votes
10k views

Samsung RF4267HARS. First I found water in the bottom of the Refrigerator compartment and on the floor under the refrigerator. Now the food in my Flex Drawer is freezing. What should I fix or replace? I have been reading that the heaters are faulty and the drain sensor fails as well. Should I change out both while I am inside there?

  • Scott asked 10 years ago
  • last active 10 years ago
0 votes
6k views

How do you install the water tank assembly? I can see the water tank leaking causing water to pool in my refrigerator. I see where they exit the interior of the refrigerator, but can not locate where you connect the new part to the refrigerator. Thanks.

  • Tammy Ratliff asked 10 years ago
  • last active 10 years ago
0 votes
3k views

I have a Kitchen Aid Superba double oven. The upper oven is lighted with the probe icon. i can not get the oven to heat or to shut the icon off. i have tried inserting the probe and removing it to no avail. the lower oven seems to working properly ,. Can you please advise.

Thanks in Advance
Scott Hynes

  • Scott Hynes asked 10 years ago
  • last active 10 years ago
0 votes
2k views

I have a kenmore elite HE4 that will run for a while until it get very hot and cuts off. I have checked the thermo cutoff fuse, the heating element, thermostat high limit, and thermo cut off per your videos. Everything shows continuity with the meter. I have noticed that the heating element does not cycle on and off per your video. For what it is worth, it does not look like the entire heating coil itself is red either. There is an inch or two of it that does not look red to me. Is it possible there is an issue with the heating element that I am missing.

  • Brett Davis asked 10 years ago
  • last active 10 years ago
0 votes
3k views

I washer a large load today and now my washer will not spin. I seems to drain and fill ok and I can hear the motor when I put it on drain only setting. Can you please tell me ways to diagnos and fix the potential issues.

Thanks

  • Koree asked 10 years ago
  • last active 10 years ago
0 votes
2k views

whirlpool ser# ss3152238, problem woke up this morning fridge was not cold (warm) freezer side really cold with frost on all meat packages, fridge side has two vents one top, one bottom this one has ice on it ,allso lower crisper ben has ice on it, when I checked the freezer side I can hear fan motor running, hope this help thanks

  • michael asked 10 years ago
  • last active 10 years ago
0 votes
3k views

the refrigerator is not cooling. it appears the freezer is working. bottom rear of fridge has motor constantly running quietly. thanks

  • Art asked 10 years ago
  • last active 10 years ago
0 votes
2k views

When it reaches rinse and spin cycle machine stops make a noise then just hums i change the drain pump still same problem also tested the motor assembly

  • Guest asked 10 years ago
  • last active 10 years ago
0 votes
3k views

My dispenser does not dispense any water or Ice. Although if I initiate the dispenser at the same time pull down with my index finger to initiate the movement , It does work. The other part is, If I loosen the screws holding the assembly in place and Pull it toward me just a little it also works. Very strange. I’m missing something, Just don’t know what it is…Can you help

  • Bob Henderson asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Two year old refrigerator making ice but not dispensing through door. Water dispenser is working. What is most probable cause?

  • colin asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Moved side by side, water& ice through the door fridge into garage. Water not hooked up. Have 2 to 3 inches of ice built up on floor of freezer and ice building up on top as well.

Just had a repairman here, he checked the drain and it was working. He said he didn’t know what else could be wrong.

Please help!!!

Thanks!

  • Jane asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Washer off balance during every spin cycle. No matter load size.

  • D.H. asked 10 years ago
  • last active 10 years ago
0 votes
2k views

I saw the similar video on youtube:
https://www.youtube.com/watch?v=Sn1yimizKWA

I know the drain Gromme needs to be replaced. The only doubt i have is that why did you remove the back portion to drain water? I have drained the water from the bottom however, could you please tell me the purpose of draining water by opening the back grill?

  • sam asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Hello,
Our refrigerator is now 6 years old. About a year ago we noticed the refrigerator temp was getting warmer and the freezer temperature was getting colder than what was displayed on the LCD screen. The temperature is about 10 degrees warmer in the refrigerator and 10-15 degrees colder in the freezer. We also heard the evaporator fan started to get loud. We took the refrigerator apart and had to de-ice the coils in the refrigerator. There was ice covering from the thermistor, evaporator line, heater, down to the coils, all the way down to the drain.

We have checked the seal on the refrigerator doors – they are fine. We have cleaned the dust from the back of the refrigerator as well as underneath. We have made sure there was at least a 2″ clearance from the refrigerator to the wall and counters. An HVAC technician has come to our house twice to replace some of the parts. I believe a new control board was even replaced. I have the part numbers, just not with me now. Once the refrigerator has been de-iced, the temperature will start to warm in the refrigerator/colder in the freezer within 2 weeks. We’ve already spent $400 on new parts for our refrigerator, but it still isn’t fixed. We would really like a second opinion on how we could repair our refrigerator before we put any more money into it.
Please help!!!

Thank you,
Kendra & Drew

  • Kendra & Drew asked 10 years ago
  • last active 10 years ago
Showing 91 - 120 of 9k results