Brand: Fisher & Paykel

Didn’t find any error codes, unit had water left in it and wasn’t draining. Did find the pump leaking, so I’m going to be installing a diverter and pump. The only part number I could find was 426862P. Is that right?

What would cause this?

Checked the inlet valves, hoses, made sure I had water to the unit – it all looks good. Am now wondering if there’s an issue with the drain pump that is causing the unit not to start a cycle at all because the customer says it hasn’t been going into drain by itself, she was manually making it. What’s the part information for the pump if I do end up needing that?

DCS WOT-230 only heating to 265 degrees on top oven bottom ok, remove oven check elements, stats, all wiring connections, top sensor and lower sensor was a little different in ohms, so swapped them now top oven heats to 320 only when set for 350, lower oven still works fine, I thinking that the MCB is bad, anyone have any experience with this issue?

I just applied the reset button on the heater housing thermostat and ran an operation test that was successful. Should I price out that thermostat for replacement or will that work?

My Fisher&Paykel makes the room hot while running & dryer seems to overheat .

In getting it apart, looks as though I need a a diverter valve, does someone have time to get me the number? My lookup isn’t working very well and I’m in front of the torn down unit right now. Need to get this estimate written up.

My Fisher&Paykel washer is making a squealing noise.

My Fisher & Paykel Washer will not drain or go into any other cycles.

I am looking for a Fisher and Paykel controller for a GWL10US washer. Part # 426930P. .

I went to look at a Fisher washer the other day and found a bad control board, and the drain pump was slightly frozen but I did not test it with ohm meter. I was afraid to order a new control board, because I am under the impression that the board was knocked out by the pump being shorted by water dripping on it or maybe even the motor or who knows what elect could have caused it. The control board is $147.00 and it would be sad to put it in and have it knocked out again.

Any Ideas on what all I need to check to make sure new board is not knocked out or should this machine be condemned?

My Fisher Paykel electric dryer is not heating.

My Fisher Paykel dryer is not heating intermittently.

I have a dish drawer that overfills.

Parker &Fisher, not spinning motor getting hot? Is there a way to know transmission is bad? How do you put this machine in diagnostic mode?

when i got to the job both drawers were flashing f1.
i dried out the bottom by the flood switch and it worked.
the customer said not that when they do a few loads the f1 comes back on

Washer isn’t going into spin cycle?

Washer code 159

              Unit is not making ice. Unit has flex tray ice maker, could not locate any harvest button for the ice maker. The display was not working on front of door, fixed damaged wiring to get display running (On off switch for ice maker on display, display was not functioning for years),    After this worked, was looking for fault codes on main display based on tech manual, none showed. Put unit in to test mode, would not show any error codes on front display. Based on tech manual, the control has blinking lights on ice maker module part of PCB, there was no blinking lights that indicated any problems with ice maker. Followed tech manual to OHM check motor, switch & thermistor based on temp guide from UI, all checks out fine. Ohm’d out the water valve, this checks out fine, water pressure through front is great. Is there any way to cycle this ice maker? Or a way to activated water valve perhaps by switching the inlet wires and pressing for water?  Thanks in advance 

How do you remove the basket from the drive unit?

My unit has FC error code and will not start ? Can you help

Display keys are not woking properly, can you give me a video on this model ? Thanks

Dryer making a squeeling noise when running? Need video on drum bearing kit on how to repair and how to gain access to the inside.

My Fisher & Paykel washer is ripping clothes during the wash cycle.

I have been having issues with my Fisher & Paykel refrigerator

My Fisher & Paykel dryer is not heating.

I am having a problem with a Fisher & Paykel Washer.