Brand: Fisher & Paykel

The drum will not spin on my dryer.

The water will not drain out of my Fisher & Paykel washer.

The clothes are still coming out of the dryer wet.

My dryer is not drying my clothes all the way

The drum will not move on my Fisher & Paykel dryer.

Having an issue with a Refrigerator

My dryer will not spin do you have any suggestions to rectify this issue?

Can you tell me what could be causing this issue on a Fisher & Paykel Washer? It is having these problems: Will not start.

My Fisher & Paykel dryer is making loud high pitched noises

I am having a problem with a Fisher & Paykel Washer.

My Fisher & Paykel dryer is not heating.

I have been having issues with my Fisher & Paykel refrigerator

My Fisher & Paykel washer is ripping clothes during the wash cycle.

Dryer making a squeeling noise when running? Need video on drum bearing kit on how to repair and how to gain access to the inside.

Display keys are not woking properly, can you give me a video on this model ? Thanks

My unit has FC error code and will not start ? Can you help

How do you remove the basket from the drive unit?

              Unit is not making ice. Unit has flex tray ice maker, could not locate any harvest button for the ice maker. The display was not working on front of door, fixed damaged wiring to get display running (On off switch for ice maker on display, display was not functioning for years),    After this worked, was looking for fault codes on main display based on tech manual, none showed. Put unit in to test mode, would not show any error codes on front display. Based on tech manual, the control has blinking lights on ice maker module part of PCB, there was no blinking lights that indicated any problems with ice maker. Followed tech manual to OHM check motor, switch & thermistor based on temp guide from UI, all checks out fine. Ohm’d out the water valve, this checks out fine, water pressure through front is great. Is there any way to cycle this ice maker? Or a way to activated water valve perhaps by switching the inlet wires and pressing for water?  Thanks in advance 

Washer code 159

Washer isn’t going into spin cycle?

when i got to the job both drawers were flashing f1.
i dried out the bottom by the flood switch and it worked.
the customer said not that when they do a few loads the f1 comes back on

Parker &Fisher, not spinning motor getting hot? Is there a way to know transmission is bad? How do you put this machine in diagnostic mode?

I have a dish drawer that overfills.

My Fisher Paykel dryer is not heating intermittently.

My Fisher Paykel electric dryer is not heating.

I went to look at a Fisher washer the other day and found a bad control board, and the drain pump was slightly frozen but I did not test it with ohm meter. I was afraid to order a new control board, because I am under the impression that the board was knocked out by the pump being shorted by water dripping on it or maybe even the motor or who knows what elect could have caused it. The control board is $147.00 and it would be sad to put it in and have it knocked out again.

Any Ideas on what all I need to check to make sure new board is not knocked out or should this machine be condemned?

I am looking for a Fisher and Paykel controller for a GWL10US washer. Part # 426930P. .