1 vote
1k views

THE UNIT IS INTERMITTENTLY COOLING AND I HAVE NO POWER TO THE EVAPORATOR FAN. AGAIN, I HAVE NO PAPERWORK. I COULD USE ANY SERVICE DOCUMENTS AND SCHEMATICS PLEASE. TX

  • Guest asked 5 years ago
  • last active 5 years ago
1 vote
2k views

THE UNIT SHUTS OFF AT ABOUT 30 DEGREE F. THE T-STAT IS A DISCONTINUED PART. I HAVE OTHER T-STATS BUT I WAS LOOKING FOR THE WIRING DIAGRAM SO I CAN FIGURE OUT IF ONE OF THESE OTHERS WILL WORK. THE T-STAT HAS 3 WIRES AND A GROUND. I’M THINKING ONE WIRE IS ASSOCIATED WITH THE DEFROST CYCLE? ANY HELP WOULD BE APPRECIATED.
THANKS
HAPPY NEW YEAR
BILL

  • Guest asked 5 years ago
  • last active 5 years ago
1 vote
1k views

i changed the transmission on the machine. the original problem is corrected.
how ever i feel that the tub is not sitting rite and when it goes into high-spin it knock ageist the side of the machine

  • Guest asked 6 years ago
  • last active 6 years ago
1 vote
2k views

I have water to the filter. Where do I go from here?
Does this Kenmore / LG fridge have a holding tank? And where is it? I have walked my customer thru a few troubleshooting issues, to eliminate the obvious.
We have determined that the flow of water stops at the filter. Or water gets to the filter, then after that, who knows. I replaced the valve about 6 weeks ago. Now the water dispenser just stopped working.
I am going over to his house tomorrow AM, and I am asking you guys for advice on what to look for. I tried searching online to see where the holding tank is, but no luck. I’ll do the typical inspection of the lines, look to see if the line is frozen at the dispenser, etc.
But primarily 2 questions.
1. Is there a holding tank, and how can I get to it?
2. Is it possible that the dispenser on / off contact is broken? If so, how can I test it?

As always thank you

0 votes
1k views

The control lock light flashes and beeps. The tech sheet does not have anything. I unplugged the dryer in hopes it would reset. No luck. Thanks for your help.

  • rodney asked 7 years ago
  • last active 7 years ago
0 votes
2k views

Convection part of oven will work but the microwave part does not.

  • Tommy Combs asked 8 years ago
  • last active 8 years ago
0 votes
2k views

Hi. My garbage disposal is humming but not working. I used my Allen wrench to loosen the blades. The water is draining now but nothing else. The reset button is pushed in. It hums and that’s about it. Also, when I touch the disposal, it’s hot. Is that a red flag or is that from me trying to get it to work by turning it off and on.? Thanks so much for your help!!

  • Elle C. asked 8 years ago
  • last active 8 years ago
0 votes
2k views

Moved side by side, water& ice through the door fridge into garage. Water not hooked up. Have 2 to 3 inches of ice built up on floor of freezer and ice building up on top as well.

Just had a repairman here, he checked the drain and it was working. He said he didn’t know what else could be wrong.

Please help!!!

Thanks!

  • Jane asked 8 years ago
  • last active 8 years ago
Showing 8 results