1 vote
137 views

Would like to know how to troubleshoot icemaker not making and dispensing ice. Ice maker has been replaced previously.

0 votes
111 views

UPRIGHT BUILT IN FREEZER, THE CONTROL PANEL WENT BAD ON IT. THE FREEZER STILL HAS POWER.
NO DISPLAY AND NO COOLING

  • jubalde asked 5 months ago
  • last active 5 months ago
0 votes
442 views

I have customer with above model, and issue is freezer is not freezing to desired temperature, it only reach up to 2 centigrade, I change, thermistor/ temperature sensor. I check compressor running dry well, I also change relay and new capacitor. But still I am not able to reach temperature up to -10 and above, what should I check oe change the parts to recommended. Thank you.

0 votes
553 views

This standalone freezer is not getting power to the compressor. Turned the defrost timer and still nothing. Not sure how to test the timer. Or test the cold control

  • RBair asked 2 years ago
  • last active 2 years ago
0 votes
669 views

I have a Whirlpool Model GI6SDRXXQ02, Serial # K11191550 Refrigerator that accumulates ice below the freezer section about an 1/8″ thick and then water leaks out onto the floor as the freezer door has frost due to the icing. This just started this year and I have had this Ref. 6 or so years.

0 votes
627 views

Need daignostic sheet or manual for model GBE10ESJBSB

0 votes
760 views

Need a service manual on this model.

0 votes
516 views

There is moisture building up in my freezer.

0 votes
656 views

My washer is giving off a burning smell.

0 votes
731 views

My freezer just starts then stops.

0 votes
731 views

My freezer is not cold enough.

0 votes
521 views

The door on my freezer will not seal properly.

0 votes
490 views

My freezer is not level.

0 votes
668 views

My freezer just turns on for a short period of time then shuts off.

0 votes
566 views

My freezer is not cooling good enough.

0 votes
485 views

The controls on my freezer are not working right.

0 votes
476 views

My freezer is leaking water from somewhere.

0 votes
728 views

The lights on my control panel will not come on.

0 votes
592 views

There is a layer of frost covering everything inside.

0 votes
653 views

My icemaker has been making hollow icecubes.

0 votes
577 views

The door on my freezer will not stay shut.

0 votes
505 views

My GE freezer will not turn on or do anything.

0 votes
454 views

The interior light flashes as well, when I close the door I can reset my temperature to my desire setting until the doors open again then it resets once again. You may contact me at 606-349-6700 or 606-349-6717.

Thank you for your time and have a nice day

  • Guest asked 3 years ago
  • last active 3 years ago
0 votes
894 views

I’ve checked evaporator coil for ice buildup. No ice, fan is working, freezer thermostat has continuity , freezer thermistor good, door seal in good shape and clean, no gaps, condenser is running but hot to touch, relay isn’t clicking, no unusual noises, door controller reading”high temperature” ,set on lowest setting #7 temperature is 23. Any ideas?

  • Guest asked 3 years ago
  • last active 3 years ago
1 vote
1k views

Ice filter not changed in two years and existing small amount of cubes are small.

What is the method to cycle ice maker and perform test:

I will assume I have to fix a defrost thermostat/thermistor assembly. I need to be able to test and disassemble freezer back panel and ice maker Dissasembly.

  • Guest asked 3 years ago
  • last active 3 years ago
1 vote
948 views

THE UNIT COOLS FINE, HOWEVER, THE “DOOR AJAR” ALARM LED IS LIT AND BEEPS. I HAVE GONE THROUGH THIS UNIT AND COULDN’T FIND ANYTHING WRONG WITH THE INTERIOR LIGHT CIRCUIT, WHICH IS CONTROLLED BY THE DOOR SWITCH. THIS LED ME TO BELIEVE THE FAULT WAS IN THE BOARD. I HAVE A NEW BOARD INSTALLED AND HAVE THE SAME ISSUE. ANY IDEAS? THANKS

  • Guest asked 4 years ago
  • last active 4 years ago
1 vote
1k views

THE UNIT SHUTS OFF AT ABOUT 30 DEGREE F. THE T-STAT IS A DISCONTINUED PART. I HAVE OTHER T-STATS BUT I WAS LOOKING FOR THE WIRING DIAGRAM SO I CAN FIGURE OUT IF ONE OF THESE OTHERS WILL WORK. THE T-STAT HAS 3 WIRES AND A GROUND. I’M THINKING ONE WIRE IS ASSOCIATED WITH THE DEFROST CYCLE? ANY HELP WOULD BE APPRECIATED.
THANKS
HAPPY NEW YEAR
BILL

  • Guest asked 4 years ago
  • last active 4 years ago
0 votes
680 views

THE “DOOR AJAR” ALARM KEEPS SOUNDING. IT STOPPED FOR ABOUT A WEEK AND THEN CAME BACK. I CHANGED THE DOOR SWITCH WITH NO EFFECT. THE UNIT IS COOLING WELL AND THE DOOR SHUTS PROPERLY. I’M THINKING IT’S IN THE BOARD. ANY THOUGHTS WOULD BE APPRECIATED.
THANKS

  • Guest asked 4 years ago
  • last active 4 years ago
0 votes
720 views

Not cooling properly in freezer

0 votes
1k views

I have an issue with a Freezer, it’s a Frigidaire and this is the problem I am seeing: Intermittent cooling

Showing 1 - 30 of 69 results