0 votes
1k views

electrode not firing. do smell the gas though. large oven does work.

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
1k views

the bake and the broil work but when I put it on self-clean the door will lock and go for about a min and then it will stop
I see the blue light labeled OVEN blink 4 times and the blue light labeled HEATING blink 3 times
please advise

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
1k views

Preheated but after that when the ignitor gets red again to light the gas it doesnt preheat. Only couple years old. Ignitor is good. But the temperature will not pass 120F. Can diagnostic manuals for this unit

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
2k views

If i set electric oven to 350, the oven preheats and shuts off around 350 and i get a 43 error code. I crossed referenced the code and the internet tells me it is a faulty sail switch. I have taken the oven a part and cannot locate the sail switch. Looking up on your site and the drawings, i do not see a sail switch. Trying to isolate the problem. Any ideas
The same issue in bake and broil. I am not sure when the fans should turn on (they have not turned on when i have tried heating the oven)

  • Guest asked 4 years ago
  • last active 4 years ago
1 vote
5k views

My customer has this large Thermador oven, and the power went out. This caused just the main large oven to not function at all. It just displays Call Thermador for Service. Everything else works except for the main large oven. I wanted to see if you know how to reset this main board or know what is causing this issue.

0 votes
1k views

UPRIGHT BUILT IN FREEZER, THE CONTROL PANEL WENT BAD ON IT. THE FREEZER STILL HAS POWER.
NO DISPLAY AND NO COOLING

  • Guest asked 4 years ago
  • last active 4 years ago
1 vote
1k views

Would like to know how to troubleshoot icemaker not making and dispensing ice. Ice maker has been replaced previously.

  • Guest asked 4 years ago
  • last active 4 years ago
0 votes
2k views

Origonally the double oven had F64 Error code while either oven was on. Both fans working, we changed out the main control board. Now F64 error code after the top oven runs for a minute. The bottom oven works half the time, other half F64 pops up. There is no sell switch in this unit. What is causing this error code to pop up?

0 votes
428 views

Origonally the double oven had F64 Error code while either oven was on. Both fans working, we changed out the main control board. Now F64 error code after the top oven runs for a minute. The bottom oven works half the time, other half F64 pops up. There is no sell switch in this unit. We then replaced both cooling fans in both the upper and lower oven. Now after a while both ovens are not working and they have the original error code. What do we do next? Customer does not want to replace oven.

0 votes
445 views

THIS UNIT WAS ORIGINALLY OPENING ON IT’S OWN THEN IT WOULDNT DO THIS FEATURE AT ALL.

0 votes
183 views

Thermador: This unit is eventually getting to temp but it is taking a long time. This Bake will turn on for 10 seconds then turn off, then turn on again until it eventually gets to temp but it takes a really long time.

Showing 31 - 41 of 41 results