Brand: Thermador

This unit has a new noise when she put larger cookware. It doesn’t makes noise all the cookwares she has.
What part do we need to replace in order to fix this unit? If it is normal, what exponation should we give out?
Are there any suggested cookware we have to use? Do we have to use Thermador suggested cookwares?
Thank you.

Need some extra eyes to take a look at this. Hopefully I can attach the information that is needed to try to determine how to properly wire this up.
Model of inline blower is VTI1010D

The hood and inline blower were installed in a house. New owner didn’t like it. Builder had it taken out and installed in another house. There is a connecting wire harness that runs between units. Naturally
that wiring harness could not be removed from original house. Electrician cut off the connecting end plugs to be able to match up wires. He wired it up and it don’t work. Builder saved the connecting ends, but that don’t help because
electrician took cut off wires out of plugs.

I have acquired information on wiring diagrams and schematics for hood and blower. I also find conflicting differences.
Here’s what I have come up with.

White wire from hood connects to blue wire at blower.
Brown wire from hood connects to brown wire at blower.
Red wire from hood connects to white wire at blower.
Blue wire from hood connects to red wire at blower.

Thanks in advance

Error code 1006 on Thermador

electrode not firing. do smell the gas though. large oven does work.

the bake and the broil work but when I put it on self-clean the door will lock and go for about a min and then it will stop
I see the blue light labeled OVEN blink 4 times and the blue light labeled HEATING blink 3 times
please advise

Preheated but after that when the ignitor gets red again to light the gas it doesnt preheat. Only couple years old. Ignitor is good. But the temperature will not pass 120F. Can diagnostic manuals for this unit

Ice selected On panel. Water filter just replaced. Cube tray full with frozen ice but stopped dispensing and seems almost like it’s jammed. Can I please get full technicians manual I want to see how to run a diagnostic.

If i set electric oven to 350, the oven preheats and shuts off around 350 and i get a 43 error code. I crossed referenced the code and the internet tells me it is a faulty sail switch. I have taken the oven a part and cannot locate the sail switch. Looking up on your site and the drawings, i do not see a sail switch. Trying to isolate the problem. Any ideas
The same issue in bake and broil. I am not sure when the fans should turn on (they have not turned on when i have tried heating the oven)