My dryer is displaying error code.
- Patrick's Appliance Service asked 9 years ago
- last active 9 years ago
My LG refrigerator is not cooling properly.
- Patrick's Appliance Service asked 9 years ago
- last active 9 years ago
Svc Manual says to check HIGH/LOW signals from HALL SENSOR in MICOM PIN
If EJECTOR is in place: It is an initialized control so the mode can be changed to ice making control Then it goes into some discussion of if the EJECTOR is in place within 2 minutes or if it is in place within 18 mins. Im used to sticking my short piece of Romex into the different slots to check different functions, I have never seen an ice maker with electronics on the head piece. Can you experts help me. Ice maker worked till I removed it and then re=installed it. Tried new ice maker and a new inlet valve with same no ice results. Thanks
- Guest asked 9 years ago
- last active 9 years ago
We are servicing an LG washer that originaly came up with UE error code and the suspension rods were replaced. The UE error code continues but now the cycle time starts to jum around, it goes fron 10 to 15 to 30 minutes. Any suggestions as to what could cause this?
- mytechjoe asked 9 years ago
- last active 9 years ago
I have a LG Washer that is not working
- T&G Appliance Repair asked 9 years ago
- last active 9 years ago
Dryer Motor will not run when start switch is activated
- Fred Abernethy asked 9 years ago
- last active 9 years ago
I have a LG Refrigerator that is not working
- T&G Appliance Repair asked 9 years ago
- last active 9 years ago
My LG washer keeps displaying an error code and i don’t know what it means.
- T&G Appliance Repair asked 9 years ago
- last active 9 years ago
