Brand: Thermador

Thermador: This unit is eventually getting to temp but it is taking a long time. This Bake will turn on for 10 seconds then turn off, then turn on again until it eventually gets to temp but it takes a really long time.

Hi Folks,

A Happy & Safe Fourth to all!

This unit is in very good condition and the problem element has not been used that much. Facing the unit it is located on the lower left, smallest element of the bunch. You turn the switch to the on position and the element switch lights up. Set the heat temperature and that lights up too. But no heat at all. Now I took the cooktop out and the element tests okay. Actually there is no wear at all on the element. Looked for disconnected wire(s) found none. Really don’t know where to go from here. Where is a good place to get a break down of Thermador products? Looking for some expertise from the Video Family.

Thank you,
Jan
Barney’s Appliance
Palm Bay, FL

Customer stated that the temperature isn’t right. Some times pre-heating isn’t working. This unit has an issue with temperature sensor?

looking for some help on this dishwasher that I went out on it couple of days ago customer had two other companies out . Unit was full filthy water . I put to drain and cleaned it out , also cleaned filter . Restarted unit it filled and didn’t wash sounded like it was draining some water out but nothing else. Found no tech sheet with unit. Ordered circulation pump when out and install put unit still doing same thing. I am not very familiar with this brand, any help would be appreciated. Thanks

I’m working on a Thermador range issue is with the top burners all igniters are working fine but the gas takes very long to open ( can’t hear it) , same issue with the griddle except that on this one you can see the spark going off before the gas comes on ,no flame , it looks like out of sync. I check the burner holes all are clean ,the issue is the gas is not heard until several clicks later. Any ideas or a manual for this one?

Hi,
Do you guys have any experience with the error code I mentioned above?

CUSTOMER SAYS THAT THEY HIT POWER BUTTON, IT STAYS ON FOR BRIEF MOMENT AND THEN SHUTS OFF. THEY HAVE TO PRESS THE POWER BUTTON AIN TO KEEP TURNING IT ON.
ERROR CODE F34 COMES ON AFTER POWER FADES. Tried to test power line going into unit to main board but not sure if low voltage should be present.

This unit has a new noise when she put larger cookware. It doesn’t makes noise all the cookwares she has.
What part do we need to replace in order to fix this unit? If it is normal, what exponation should we give out?
Are there any suggested cookware we have to use? Do we have to use Thermador suggested cookwares?
Thank you.

Need some extra eyes to take a look at this. Hopefully I can attach the information that is needed to try to determine how to properly wire this up.
Model of inline blower is VTI1010D

The hood and inline blower were installed in a house. New owner didn’t like it. Builder had it taken out and installed in another house. There is a connecting wire harness that runs between units. Naturally
that wiring harness could not be removed from original house. Electrician cut off the connecting end plugs to be able to match up wires. He wired it up and it don’t work. Builder saved the connecting ends, but that don’t help because
electrician took cut off wires out of plugs.

I have acquired information on wiring diagrams and schematics for hood and blower. I also find conflicting differences.
Here’s what I have come up with.

White wire from hood connects to blue wire at blower.
Brown wire from hood connects to brown wire at blower.
Red wire from hood connects to white wire at blower.
Blue wire from hood connects to red wire at blower.

Thanks in advance

Error code 1006 on Thermador

electrode not firing. do smell the gas though. large oven does work.