0 votes
2k views

Door handle coming apart and did not notice any screws or how to adjust it can I get a service manual Or something showing me how to repair the door handle and bottom hinge most importantly the doorhandle that’s the one I couldn’t figure out although I have fixed many

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
1k views

electrode not firing. do smell the gas though. large oven does work.

  • Guest asked 5 years ago
  • last active 5 years ago
1 vote
1k views

Would like to know how to troubleshoot icemaker not making and dispensing ice. Ice maker has been replaced previously.

  • Guest asked 4 years ago
  • last active 4 years ago
0 votes
1k views

Ice selected On panel. Water filter just replaced. Cube tray full with frozen ice but stopped dispensing and seems almost like it’s jammed. Can I please get full technicians manual I want to see how to run a diagnostic.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
1k views

Hello Technicians,I have a Thermador Dishwashe that is not cleaning the dishes on the bottom rack or top rack . Dishes don’t look like they have washed at all. I thought it could be a low water issue, so I had the customer add hot water when the dishwasher stoped drawing water going into the beginning of the cycle, they said it didn’t make a difference. Please advise as to what else I might check. I have checked and cleaned spray arms, have Shop vacuumed out sump and drain. Thank you for you advise and help.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
1k views

Preheated but after that when the ignitor gets red again to light the gas it doesnt preheat. Only couple years old. Ignitor is good. But the temperature will not pass 120F. Can diagnostic manuals for this unit

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
1k views

UPRIGHT BUILT IN FREEZER, THE CONTROL PANEL WENT BAD ON IT. THE FREEZER STILL HAS POWER.
NO DISPLAY AND NO COOLING

  • Guest asked 4 years ago
  • last active 4 years ago
0 votes
1k views

the bake and the broil work but when I put it on self-clean the door will lock and go for about a min and then it will stop
I see the blue light labeled OVEN blink 4 times and the blue light labeled HEATING blink 3 times
please advise

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
446 views

THIS UNIT WAS ORIGINALLY OPENING ON IT’S OWN THEN IT WOULDNT DO THIS FEATURE AT ALL.

0 votes
428 views

Origonally the double oven had F64 Error code while either oven was on. Both fans working, we changed out the main control board. Now F64 error code after the top oven runs for a minute. The bottom oven works half the time, other half F64 pops up. There is no sell switch in this unit. We then replaced both cooling fans in both the upper and lower oven. Now after a while both ovens are not working and they have the original error code. What do we do next? Customer does not want to replace oven.

0 votes
187 views

Thermador: This unit is eventually getting to temp but it is taking a long time. This Bake will turn on for 10 seconds then turn off, then turn on again until it eventually gets to temp but it takes a really long time.

Showing 31 - 41 of 41 results