Brand: Viking

Unit will not start, Sights will not come on, Error on display

I NEED THE DOOR HINGES FOR THIS OVEN AND ANY INFORMATION YOU HAVE ON HOW TO CHANGE THEM AS WELL. THANKS IN ADVANCE.

Hi,

I check out the thermistor and it’s ohms out okay. Thinking about the control (diffuser) but I didn’t want to go any further due to the cost of these parts. What do you guys think?

Thank you,

JAN
Barney’s Appliance

My oven does not seem to be getting warm enough.

Moisture is building below the fridge I have seen this on several of the side-by-side Vikings the drain pan would be on the right side and there is a gutter that runs from the left side which is the freezer drain hole to the right side and it’s always really wet around the beginning of the gutter which is the bottom of the freezer side, it would be covered In really big droplets hanging down. The little axle fan located in the front right came on after resetting the fridge which I am assuming is to dry out the bottom of the unit. Do you guys have any ideas what could be causing this or what I can do? I put a cookie sheet there temporarily. Diagnostic mode didn’t tell me jack.
This unit does not have a drain pan heater but the drain pan is wet inside so I know water is getting in there and there is no water damage below the drain pan only wear those droplets are hanging from

Temps 100 degrees lower, Will not heat up all the way, No heat, Partially heating, Error on display.

Dishes not cleaning, Soap in the bottom of the tub

I’m following your video for replacing an axial fan motor: https://www.youtube.com/watch?v=-67goBr-cFw However my fan motor is connected to the bracket not by metal screws as shown in the video, but by four silicone connectors. I don’t know how to disassemble these silicone connectors and then reattach them once the new fan motor is on the bracket. Please email me or call/text 8326462529. Freezer is powered down so immediate response requested. Thanks

Not starting.

I watched this video on your site: https://www.appliancevideo.com/premiumotr/viking-stove-bake-element-oven-not-heating/

When i pulled the white wire and red wire spade connectors off i put a test to them and had 125 volts;
I hooked them back up to Bake element it was hard to get accurate reading on volt meter. It was kind of reading 20 volts? Would this mean my Bake element is bad ?

Partial heat, Error on display, Not heating

Hi there,
My customer complains that the broil makes an explosion sound and she smells gas when she uses the broil, it does not happen all the time it just intermediate, when I tested it it was working fine. This model does not have ignitors just spark electrode on both bake and broil. Do guys experience any similar issue with this model?

She also mentioned that when it happens the spark electrode sparks once and then she doesn’t hear it anymore. When I was there it sparked 2-3 times and then lit up with no issues, I was there for 30 min and when the temp when down the broil lit up again with no issues

Thanks,
Don

Unit stops at random times.

I have had several of these Viking ranges where they have a gas Leak on the tube that leads from the safety valve on the gas manifold to the gas valve for the bake section of the range. I called biking and they gave me the wrong part number when I looked at the photo and I was wondering if somebody can provide me with the proper parts blow up so I can actually look at it myself. It’s a tube about 4 feet long.
IT IS NOT PART #PB002043

No Spark, Continual spark

10yr old $10,000 viking that will not dispense water and slow ice production. water line inside of freezer door is frozen. freezer temp is normal,should I just replace ice maker? can the freezer door insulation become compromised? is there a water line heater in the door?

Issue with Viking Cooktop: Stains on burners

could you send me the manual of ice machine parts

Verona range basically identical to a Bartezzoni. Oven itself is electric and has a thermostat and a large mechanical selector switch. After tampering with it the oven selector it started to work couple days later costumer said it failed to start. Any ideas on how these units operate? Seemed like a basic system and nothing burned or broken but seems to be failing.. thermostat? The large oven started to work after securing the leads on the selector switch.

Thanks for asking a question. I looked up that model number and we have a video on a similar issue. I put a link below the answer.