The back left burner on my Hotpoint stove is not working.
- Patrick's Appliance Service asked 9 years ago
- last active 9 years ago
I replace the main control board, defrost thermostat, and defrost heater and still have the problem.
- Guest asked 8 years ago
- last active 8 years ago
My Hotpoint dishwasher randomly shuts off.
- Curtis Appliance Repair asked 9 years ago
- last active 9 years ago
My customer’s Hotpoint Refrigerator is having some issues. Not producing ice
- Harley Clark asked 7 years ago
- last active 7 years ago
My Hotpoint refrigerator is not getting cold enough.
- Patrick's Appliance Service asked 9 years ago
- last active 9 years ago
My Hotpoint washer will not agitate or spin.
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
GOOD MORNING. I DID NOT CHECK THIS FRIDGE YET. I AM BEING TOLD THAT THE FRIDGE TEMP IS FINE, BUT THE FREEZER IS NOT. ALSO, THE ITEMS IN THE FRIDGE VEGIE STORAGE DRAW ARE FREEZING. I NEVER WORKED ON A HOTPOINT BEFORE, BUT THIS SOUNDS BACKWORDS. ANY HELP WOULD BE GREATLY APPRECIATED. THANKS, TODD FROM NY.
- Guest asked 8 years ago
- last active 8 years ago
My defrost heater is not testing out properly.
- Fred Abernethy asked 7 years ago
- last active 7 years ago
Problem with a Hotpoint Refrigerator
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
It’s gas by the way. What part would I need?
- Tyler A asked 10 years ago
- last active 10 years ago
THE HOTPOINT MICROWAVE DOEN NOT OPERATE BECAUSE THE THERMOSTAT AT LOCATION#: 138 ON THE DIAGRAM DOES NOT HAVE CONTINUITY. THE PART# IS WB27X11213 110/0.
THE MARKINGS ON IT IS KSD210 AND 70.
IS KSD201 THE GENERIC PART NUMBER, IF SO WHAT DOES THE 70 MEAN?
IS IT’S ROLE TO PROTECT THE MAGNETRON?
I NOTICED LOCATION# 117, PART#: WB27X11208 70/0 AND LOCATION# 138, PART# WB27X11212 120/0 AND LOCATION# 130 AND LOCATION# 130, PART#: WB27X11210 160/0 ARE ALL GOOD. IF THE 70 IS A TOLERANCE LEVEL, COULD THIS HAVE BEEN WRONGFULLY MIXED UP WITH LOCATION 117 THAT HAS A 70/0 NOT LOCATION 138 THAT HAS 110/0? DOES IT MAKE THAT MUCH OF A DIFFERENCE? IF I REPLACE THE THERMOSTAT THAT IS BLOWN AT 138 WITH A HIGHER NUMBER, FOR INSTANCE, 110/0 INSTEAD OF 70, MIGHT IT DELAY BLOWING, THEREBY DAMAGING THE MAGNETRON?
- Guest asked 6 years ago
- last active 6 years ago
I’m curious as to what would be causing my gas oven to preheat and beep as if ready, but then not maintain it’s temperature after that?
- Stephanie A asked 10 years ago
- last active 10 years ago
Do you have the service manual for rvm5160dh1ww- is a hotpoint and for jvm7195df1bb- is a GE? The ge comes one but does not heat. How do I eliminate the control board from the magnetron and magnetron thermostat?
- Guest asked 6 years ago
- last active 6 years ago