Brand: Jenn-Air

I have installed three sets of door hinges. I know these hinges don;’t work because I have run into a few of these stoves.
Has anyone heard of a solution to this? Whirlpool has to know about it because I had my parts supplier inquire a year ago. I had one customer that was ok with a latch on the side of his stove. Any suggestions ?
Thanks,

I looked at this dishwasher yesterday. . Complaint: Dishes not getting clean anymore like they use to and food is left on the dishes. I stripped the dishwasher down and checked the impeller, made sure all the spray arms were clear, and sump was clean. Unit was very clean with little to no debris. Tested the unit and it appears all spray arms are turning and upside down cups in the top rack are quickly filling with water. Water is hot. Good wash action. I did find that the turbidity sensor failed twice in diagnostics but then made it through the test two other times.I did not ohm it out. Heating element is getting hot. If the turbidity sensor is failing, would this affect performance or make changes such as shortening or eliminating wash cycles? Would changing the turbidity sensor be the best course of action? Thank you for any advice.

Hello I have a question on a Jenn-Air Oven. I’m noticing these issues: Oven roller rack could fall off

The unit will start to heat and then I get the error code f8e0 underspeed fan.
I do hear and feel the fan blowing.
Please advise

I have a a 48″ Jenn-air range ; customer complain that main oven flame was sputtering and shut off. They started smelling gas he called gas company they came out and said he had a gas leak. I went out and order a regulator. Replaced regulator unit still does the same thing all other burners are Ok could it be the safety valve?

I need to remove glass top on cooktop were are the screws I need to ge to too take apart

My Jenn Air dishwasher JDB1270AWY has started making a grinding noise during part of the cycle. It is cleaning great and seems to be draining fine. Ideas?