0 votes
2k views

Problem with a LG Washer

0 votes
2k views
0 votes
8k views
  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

Need service manual

0 votes
1k views

My LG washer is completely unresponsive.

0 votes
1k views

My range will not heat up to the set temperature.

0 votes
1k views

My LG dryer will not spin.

0 votes
1k views

My clothes are still coming out damp after two cycles.

0 votes
1k views

I believe my microwave is not getting hot enough.

0 votes
1k views

The burners on my cooktop will not stay on

0 votes
2k views

Not drying properly.

0 votes
2k views

My LG refrigerator is leaking from the drain pan.

0 votes
1k views

My LG refrigerator is leaking water.

0 votes
2k views

One of the fans inside the unit sounds like its grinding on something.

0 votes
1k views

I dont think the air coming out of the unit is cold enough.

0 votes
1k views

The selector switch on my window air conditioner is not working.

0 votes
2k views

My air conditioner is leaking water.

0 votes
2k views

My LG air conditioner smells like refrigerant.

0 votes
2k views

My window air conditioner is not keeping the proper temperature.

0 votes
2k views

The water valve buzzes when I dispense water from door and when ice maker is filling. I replaced water valve and it was fine for a week then started buzzing again. I replaced it again and this new one buzzed right away. Can you help?

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
1k views

Door is warped, Door is bent, Door is cosmetically damaged.

0 votes
2k views

Scraping sound during operation, longer than normal dry times.

0 votes
2k views

No power to PCB main.

0 votes
2k views

leaking water, ice on the freezer floor, buzzing sound from the back of unit.

0 votes
2k views

Noisy or vibrating.

0 votes
2k views

flickering tub light.

0 votes
2k views

Loud noise, long dry time.

0 votes
2k views

Flames coming up the side.

0 votes
2k views

I am looking for main pcb board lg model WM2277HW/01 board 6871ER1078T.

0 votes
2k views

The flame will ignite sometime for 3 sec. Or less or sometimes for longer. But when the flame is not on it had a very strong smell of gas. Inside the drum.
I disconnected exhaust fan so I know that’s not the issue.
However sometimes the flame goes on and it does not smell like gas.
Most of the time the flame goes on for 3 seconds then goes off and has a terrible smell of gas

  • Guest asked 6 years ago
  • last active 6 years ago
Showing 61 - 90 of 905 results