Brand: Samsung

The buttons on my Samsung washer are not working.

The drum on my Samsung washer is stiff.

My washer is showing a T1C error code.

my Samsung washer will not power on.

My Samsung washer will not power on. The lights are not working.

My Samsung washer seems like it is not rotating properly.

I was looking for a video about trying to diagnose what this error code is and what we would do to diagnosis it. I want to see how complicated it might be

I have water leaking from the front of my washer.

The water in my washer is not heating up.

The door on my Samsung washer will not unlock.

My Samsung washer takes too long to fill up.

My Samsung washer shakes around during spin cycle.

My Samsung washer is making a loud noise during spin.

My Samsung washer keeps overfilling.

My Samsung washer will not turn on.

My Samsung washer will not drain the water out of it.

My washer is making a grinding noise during the spin cycle.

My Samsung washer will not finish the cycle.

My Samsung washer will not agitate.

The door on my washer will not unlock.

My Samsung washer is loud and shakes during spin.

My Samsung washer is making a grinding noise.

My Samsung washer is leaking water from the back.

Door won’t lock ‘FL’ error code.

Had a tech come out and look at it. He said the lock needed to be replaced. He replaced that and it didn’t work. Said the control board needed to be replaced, but wasn’t available. He took the lock back.

I bought a new lock and a used, but ‘tested as working’ control board. Replaced both and it’s still not working.

When you power the machine on, shut the door and attempt to wash it starts to click a few times and then finally gives off the ‘FL’ error code. The click sounds like a relay to me, but what do I know. It doesn’t sound like it’s coming from the lock, but more toward the back of the machine. I have a video I was hoping to upload, but it’s 2020 and that feature apparently hasn’t been discovered yet.

So my question is what do I do to fix it?

The initial issue was the dryer would continously run the drum and never shut off, after much research we determined it was a relay on the main control board. We ordered a new control board and I made sure everything matched before I installed, it was ordered via the model number and all part numbers did match. So I disconnected the power to the unit and installed the new control board, there were no issues installing it. After reassembly I then plugged the dryer back in and now it acts as if I have not plugged it in at all. There is no power to the display or even the light inside the dryer. I have checked with my multimeter all of the power, the dryer is recieving it’s full 240v to the control board. Everything on the control board seems to be recieving its proper amount of power. Including the the 13 DC volts going to the display unit. I also tried reinstalling the old control board that had no affect the dryer is still acting as if it has no power. Please help I am at a loss as to what to do now.

Did the new control board fry something else?
Did I miss a step somewhere on the installation?

Machine would start cycle and go down to about 9min. At this time machine would go back to 18 min. Machine generated and 8C2 error code which indicates the mems sensor or vibration sensor and a ub error code. I tested the drum and pushed down on it and thought it was the suspension. I replaced the suspension all four suspension rod and the machine started spinning when it is empty. Then when tested with an actual load machine does the same thing it times down to 9 min and then jumps back to 18 min. Now its only displaying a Ub error code . Should i go ahead and replace the mems sensor or any ideas on how i should proceed.
Model no. WA52J8700AP/A2
Serial no. 0E6H5AEH303210J

doesn’t set any codes

I need a tech sheet and service manual. There is no power to the pump.