Machine would start cycle and go down to about 9min. At this time machine would go back to 18 min. Machine generated and 8C2 error code which indicates the mems sensor or vibration sensor and a ub error code. I tested the drum and pushed down on it and thought it was the suspension. I replaced the suspension all four suspension rod and the machine started spinning when it is empty. Then when tested with an actual load machine does the same thing it times down to 9 min and then jumps back to 18 min. Now its only displaying a Ub error code . Should i go ahead and replace the mems sensor or any ideas on how i should proceed.
Model no. WA52J8700AP/A2
Serial no. 0E6H5AEH303210J
I tested the drum and pushed down on it and thought it was the suspension. I replaced the suspension all four suspension rod and the machine started spinning when it is empty.
- Guest asked 3 years ago
Hello
The 8C2 error error could have a few possibilities. See the complete diagnostics in the manual links below.
1) Possible defective Mems PBA .
2) A possible PBA wire disconnection.
- AV Repair Help answered 3 years ago
- You must login to reply
Please login first to submit.
