0 votes
2k views

My oven is not working properly.

0 votes
2k views

(Viking fridge brand. search has issues finding after error due to not selecting appliance type)
Replaced gasket and fresh food door doesn’t stay closed. NO THIS MODELS HINGE IS NOT UNDER RECALL. Tried raising the front of the fridge and nothing. Rubbed a bit of lube on gaskets, nothing. Tried udjusting the top hinge bracket in different directions and nothing. Put old gasket back on and seems to be staying closed at least a lot better than new gasket. I was thinking to heat gun the gasket until it compresses better like the old one? But why does the freezer close so well and these Viking side by sides always have issues? What are some other things I can try besides heat gun the new gasket a bit so it isn’t so thick ??

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

Won’t start and has no lights and not working. No respond when buttons pushed. Unit has power going in.

0 votes
2k views

My Viking stove is taking too long to preheat.

0 votes
2k views

My oven does not seem to be getting warm enough.

0 votes
2k views

Partial heat, Error on display, Not heating

0 votes
2k views

I have had several of these Viking ranges where they have a gas Leak on the tube that leads from the safety valve on the gas manifold to the gas valve for the bake section of the range. I called biking and they gave me the wrong part number when I looked at the photo and I was wondering if somebody can provide me with the proper parts blow up so I can actually look at it myself. It’s a tube about 4 feet long.
IT IS NOT PART #PB002043

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

My customer’s Viking Dishwasher is having some issues. Dishes not cleaning

0 votes
2k views

-Replaced right side spark module twice now (CM didnt care about left side), Every time the oven is heated the whole top section gets extremely hot and spark module over heats causing sporadic clicking until it cools down an hour later
-Oven door shuts good
-Oven does NOT have a cooling fan because its a full gas range so no circuit boards to cool in back
-I put aluminum tape around spark module area directing the venting hot air away from the module housing
-I tried running the hood vent on maximum over the range to evacuate some heat, DIDNT help

I know the electric ignition one with the DSI ignition module has had a recall to install a cooling fan but this is a 13 year old range which the top of is over heating. Decently taken care of.. Any suggestions? I was thinking to run the module under the range to a cooler area but the micro switches on the valves are getting extremely hot too and brittle

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
2k views

My Viking range will not heat up.

0 votes
2k views

Door will not stay closed

0 votes
2k views

could you send me the manual of ice machine parts

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

Indicator does two flashes next to thermostat in between pauses. Checked DSI (oven spark module) and it tested good. Even popped a new one in for good measure no change. I’m suspecting the thermostat it also has some grease in it which I know Viking addressed with a kit. Can you guys get me the diagnostic guide MOST IMPORTANTLY THE FLASHING ERROR CODE guide.

  • Guest asked 6 years ago
  • last active 6 years ago
1 vote
2k views

Will not heat, Calibration is off, Error on display

1 vote
2k views

The lights below the refrigerator doors that shine light into the freezer drawer when you open it do not go off unless I unplug the little Molex connector going through the right door for the refrigerator to the led lights. I ran the refrigerator through diagnostic mode and tested both door switches and they all seem to be fine and no error codes. When I looked at the wiring diagram I noticed there is a LED control board and Main control board. Can you guys provide me with the service and manual and tell me what you think because obviously that’s not the door switches and must be one of the circuitboard? Please don’t not just include the manuals also give an invite
Can you guys provide me with the service and manual and tell me what you think because obviously that’s not the door switches and must be one of the circuitboard? Please don’t not just include the manuals also give an input.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

Dishwasher is having some problems

0 votes
2k views

Having an issue with a Stove

0 votes
2k views

Unit stops at random times.

0 votes
2k views

My Viking range is overheating. Is there anything you can suggest to rectify this issue.

0 votes
2k views

My Viking dishwasher is not working properly.

0 votes
2k views

Costumer says Oven randomly shuts off while baking. I saw it shut off once after shutting it off every couple minutes and then restarting it so I never got to 350 even though that’s what it was said to but it randomly shut off after two minutes of running. I replace the DSI ignition module for the oven but the customer is saying that I did it again where it was getting significantly less warm in the oven in the oven just shut off. Can you guys please provide me with a wiring diagram and your technical input on what else could be regulating the system? I’m thinking that electronic thermostat that I saw there I would appreciate your guys input.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

My Viking dishwasher is making grinding noises.

0 votes
2k views
0 votes
2k views

Bad smell from sump, Will not drain, Leaking water.

0 votes
1k views

Will not fill with water, Humming noise, Error on display

0 votes
1k views

Pan under fridge is full of scummy water, should I clean it and add water and replace? its a Viking Professional 36″ refrigerator with freezer on the bottom.

0 votes
1k views

Water is cold, Unit will not run

0 votes
1k views

When you put the thermostat in bake them turn off oven bake function doesn’t turn off meaning valve still open and bake burner going EVEN AFTER UNPLUGGING.
Naturally I thought maybe poor valve and swapped the bake and broil solenoids-didn’t do anything still WOULDN’T shut the gas off. So I had an exact ignition board DSI replacement and installed it. Still having issues shutting off. Came back replaced thermostat still doesn’t shut off…?? Super simple diagram loss like nothing left to replace unless my DSI ignition board was defective which it was new.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
1k views

I am trying to access the user interface behind the knob. I am not entirely sure that it is the main control. But the oven works with the keys but not knob. I was told it is a 90% chance it is the main control but I have no clue how to access the user interface at the top behind the knob. Please help

  • Guest asked 5 years ago
  • last active 5 years ago
1 vote
1k views

Both ovens do not self clean. The big main oven turns on the oven self-cleaning mode for a brief moment and I can feel the ovens latch vibrating like it’s trying to close but then after about one minute the oven thermostat light starts flashing and so does a -red light on the back of the range on the main board behind the main oven-. Now the small oven when you set the selector switch to self clean and the temperature knob to self clean it does absolutely nothing. No light or anything.
Both ovens bake and broil fine.
Both ovens main boards had NO physical damage.
Only the main oven had any response when set to self clean. From what I read online there is a self clean board and preheat board. I did not count the flashes of the red lights and I am not there anymore. Can You guys suggest which board to replace because the main oven seem like it just had a bad latch but why did the small one not do anything?

  • Guest asked 6 years ago
  • last active 6 years ago
Showing 61 - 90 of 109 results