I have a Kenmore washer that will not remove the water from clothes in final, I have to give a second spin cycle. I have also noticed a moldy smell coming from the washer lately, what should I be looking for in the way of a repair.
Have not tried anything as of yet, not sure where to begin
- Guest asked 7 years ago
- last edited 7 years ago
Hello
I would start by checking error codes stored most common will be the Ld” error flashes if it takes longer than 5 minutes to pump out water to a point where the operating pressure switch resets. You can Press STOP/CANCEL to clear the display. It sounds like a restricted pump because of the moldy water smell is telling us it is not pumping out all of the water. See diagnostic link below to run the unit through the diagnostics mode. Matt Ace technician
- AV Repair Help answered 7 years ago
- last edited 7 years ago
- You must login to reply
Please login first to submit.
