0 votes
3k views

My dishwasher doesn’t want to drain completely. Initially I thought it was something stuck and cleaned out as far as possible down into the impeller or chopper area like a video I saw on here. Ran another cycle and same thing happened. Could it be something stuck further in the drain or pump area?

  • Noelle asked 9 years ago
  • last active 9 years ago
0 votes
3k views

I have a E01 error code on a Ascenta Dishwasher? any suggestions

  • Rany asked 9 years ago
  • last active 9 years ago
0 votes
2k views

bosch dishwasher model she6at05ucx/o5
error cod e64
we replaced the control board to no avail
need some assitance please we belieive it could be heating system , also
how do you get this dishwasher into test mode

  • Jessie asked 9 years ago
  • last active 9 years ago
0 votes
2k views

I’m having problems with this washer. Model #WFMC1001UC/13. A few months ago I changed out the drain pump on this washer and it worked for a while. When I went this time the washer would not agitate or spin but was draining great. I checked all the wiring, plugged and unplugged all the connections. I tested the washer and then it was running well. Customer stated it was spinning fine for a couple of days. Now complaint is a slow spin. Does anyone know what I should be looking at on this washer? There is a wiring diagram in the washer but I don’t have access to tech support. Any thoughts on this would be appreciated.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
3k views

The unit will actually begin to smoke if there’s a heavier load in. Where should I start?

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

This customer had been frustrated with her dishes not getting clean and was already pre rinsing, changing soaps, running on high heat, and trying everything she knew how. After arriving it did not take long to find that the spray arms were simply blocked up. After clearing them and running a quick wash to check their use, she was thrilled to have such an easy fix. Always check the basics, one is often the culprit.

0 votes
3k views

I’ve worked on a few of these, and found the limiter open, so I replaced that, but still having issues. What am I missing? There must be something else.

0 votes
3k views

There are not tech sheets or information here on this washer, anyone free to give me a quick look on the issue? Thanks.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

Am having a hard time finding the part information for this model. Need an igniter. Any help?

0 votes
2k views

This is a vent less dryer. I have moisture is building up on the back side of the access cover to get to the condenser for cleaning. After 2-3 loads in dryer water will start showing up on floor. Drain pump is working fine. Dryer dries fine.
Anybody have experience with these models or ideas what is causing this? Thanks.

0 votes
3k views

any tips on taking this dryer apart? Pictures etc.? Can’t seem to find a video.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

bosch dishwasher has power to touchpad but will not start

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

if I check water inlet valve for bosh dishwasher and it has continutity to water valve does that mean valve is ok

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
3k views

Looking at it now and there’s no tech sheet. Thanks.

0 votes
2k views

I need a new door seal for this model, anyone have time to do the lookup for me? Thanks.

0 votes
2k views

Model SHE45M06UC/50
You have to really play with the Power button to get the unit to run. I see where the Off/on switch (#424410) is the likely culprit in my mind, however I seldom work on these enough to become intimately familiar. Am I headed in the right diretion?

0 votes
2k views

This dishwasher was just re-installed after a kitchen remodel. I got called out because it wasn’t draining. I removed the knockout from the disposal the first time thinking that was the issue. Turns out it wasn’t, still having issues. This time I’m getting a bad pump but cannot find the part number anywhere. Somebody there able to look it up for me?

0 votes
3k views

Wanted to let you guys know, we’ve had a couple Bosch’s with this complaint, and there’s been nothing wrong after diagnosing. We always check wiring, controls, motor, and heater. No stored error codes, and all safety checks come back ok. Just in case you see any out there, let us know if you actually find a problem!

0 votes
2k views

I checked this unit out and only found that there seemed to be a build up of dish soap inside somehow. Assuming customer is soaking or rinsing dishes before loading and it’s migrating into the dishwasher, causing a lot of suds, and not very adequate cleaning cycles. What do you guys normally recommend to clear them? Is there a specific product you use?

0 votes
2k views

Microwave turns on for 2 seconds and then turns off. History: I changed out a blown fuse about six months ago but did not know at the time I should have changed the monitor switch. Last time it was dead and now it just turns on for 2 seconds. Any ideas what I should be looking for? Model #HMB5050/01 FD 9007100017 FCC ID ACLAP7A01

0 votes
2k views

I would like your recommendations for appliances that will last longer than 6 years like most of the brands that are produced today. My customers ask me this question daily. I suggest Speed Queen washers and dryers for laundry products but I’m not sure about the other types of appliances. I’m currently researching Bosch dishwashers. Thank you for any assistance.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

The door of my washer is locked and I cannot get my laundry or the water out of the unit.

0 votes
2k views

My Bosch dishwasher will not shut off, it continues to run.

0 votes
2k views

My Bosch oven displays “224” error and will not come on.

0 votes
2k views

My whirlpool dishwasher will not stop running.

0 votes
3k views

The washer shakes pretty violently at the beginning of the spin cycle with clothes in it. Neither sock is broken, none of the block counter balancing pieces are broke or missing, and the springs look good. If you hold the outer tub assembly it will get up to full speed, but vibrates pretty bad. Any ideas? Is there a balanced ring on this unit like some Samsung washers have?

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

We have a Bosch Dishwasher that goes straight to clean after starting. I won’t bore you with the parts that have been installed. Has anyone ran into this problem that can help?

0 votes
3k views

Its fills with water and drain it right away

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

What should I look for when the lint alarm goes off and kills the dryer? On a separate call, I replaced the belt, pulley, rollers and blower wheel. I Vacuumed Out The unit and was working fine when I left. ????

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
3k views

my Bosch dishwasher is leaking water.

Showing 1 - 30 of 151 results