Brand: GE (General Electric)

Dryer will not operate.

Complaint: water leaking from the fresh food side out the front of the fridge door and ice forming on the wall between the freezer and fridge on the fridge side about 18 inches up from the floor of the refrigerator. I have not seen this before? Has anyone run into this on a GE and know the cause? I just looked up the fridge and see that there is an evaporator in the fresh food side. A frozen drain could be contributing to the water leaking from the fridge. Would this excess moisture cause the freezing on the wall between the freezer and the fridge? I did look at the fridge briefly but did not have the time to get deep into the diagnosis. I did not check temperatures yet, I will be going back on Thursday. Thanks for any advise.

Not drying.

We had a little problem with the freezer or the door was open for a while that frees up the evaporator fan be defrosted it and everything’s working fine however we realize now that when we push the cube on the ice dispenser crushed ice comes out .
And when we put crushed ice crushed ice comes out as well

When I arrived the water valve put in a little water and then the drain pump came and continuously ran and when I went into service mode the error codes E30 and E54 were in the history. I went through the test options and made it T06 which is the pressure switch test and it went into error. I put a pressure switch on the washer and problem still occurring with the same symptoms. Thanks in advance for any help

My Electric GE oven is not heating.

The dishes do not seem to be getting dried at the end like they used to, and also not getting as clean. Thought maybe it was the control panel but it seems fine. Water pressure is good, and I cleared the spray arms of any debris and cleaned them well before putting them back in. Seems to be cycling correctly. Wasn’t sure what to check next.

Main board relay burned so replaced display PCB and now all lights flashing on display? Old board worked fine but With the burn damage one of the two heater coils was disabled now the whole unit doesn’t want to run just keeps flashing All lights and buttons.

My customer had an electrical outage the night that we had an electrical storm. He lost his cable, dishwasher, and all cordless phones.
His washer only fills, then he has to change the setting from wash to spin and drain. And only then will it empty. That’s all it does.
Is it possible that the machine got hit as well, and did something to the board? It worked fine up to that point.

It fills at the proper levels, but won’t wash.

Soap does not dispense, Poor drying.

I have a GE ref model PFCS1NFZCSS, serial ZV309662 Ice maker not making ice. part number WR30X10087. I do not see a manual switch to get this ice maker to go into a harvest mode. Freezer was at -2 F, so temp is not an issue.
How do I get the ice maker to go into a harvest?

GE front load washing machine. When you turn the machine on and hit start, it does not do anything mechanically (will not fill with water, spin, etc) but it shows the cycle counting down on the display. Pump made a noise one time but that is it. We suspect a control board but are not confident.

Sometimes the fresh food section doesn’t cool. Ran the diagnostic mode and they gave me these two error codes
006o 0510

Not cooling.

I’m having trouble figuring out why this dishwasher is not draining. I have checked the drain hose It appears to have good flow. It drains but leaves a lot of water in the tub. The drain cycle seems to short but I did not time it. This washer does not have a separate drain pump. It has the solenoid which also appears to be working right. Sump pump is clear and I pulled the motor to check for any a blockage. The DW is only about two years old. I would say low end model.

Dryer will not run, Display is blank

I recently replaced a evap fan motor (PN#wr49x25197) and supposed to update software with provided kit.

Unplugged refrigerator & made repair, plugged back in and now the display keeps rebooting, and the ice / water dispenser does not work at all, and no buttons function.

I have tried the reboot procedure GE had told me to perform by unplugging between 30 and 45 seconds, no more than a minute. This did not correct the issue, the refrigerator seems to work along with the freezer, so no operational issues from the main controller.

Customer is PISSED off and I cant get any help from GE.

I did notice that when I initially re plugged in the refrigerator, the plug contact made a spark when engaged in to the outlet, and I know how electronics are sensitive to power issues.

Hello, I love your new website.
My customer has a GE French Door fridge with the freezer on the bottom. I think the board that controls the fans is bad. I am the forth technician to service this fridge. She has had nothing but problems with it since she bought it. A year after, GE replaced the compressor. After that 3 boards were replaced. And more! Now this?..

I was going to take the latch assembly, anything else just as a precautionary measure since I haven’t got my hands on it yet?