Brand: GE (General Electric)

F79 error code

This ge fridge is showing temps different than what’s set. The big thing is the temps shown vary greatly with the set temps. With thermometers placed in the fridge and freezer they show good temperatures inline with the set temps. The fridge has never got over temp.

I NEED TO REMOVE THE BOOT HOW TO REMOVE FRONT CONTROL PANEL

My freezer drain is iced up blocked evaporator fan. I cleared ice from fan drain line that goes down throw cabinet. You can’t see drain line down by compressor compartment. The drain pan to right of compressor in back can’t see or touch drain line. any ideas how to make sure drain line open. Thanks in advance

I have a GE washer stack unit the customer says that it is squeaking “squealing” she says it was intermittent but more and louder now. Thanks so much.

Unit does not start.

WH16X10186
Support assembly is stuck and won’t release
Is there a device I can buy to free this support assembly?

Leaking water.

My GE washer will not spin or agitate.

Are you able to provide the tech sheet for this model? Model# PFS22SISBSS There is not one with the machine. Thank you.

DOOR WONT LOCK AND MACHINE WONT DO ANYTHING, what is the most probable; door latch, control board or ?…
Thanks for your help

The lid on my GE washer will not shut gently anymore.

Can this part be used on the refrigerators with plastic liners. If yes, is the wiring the same as with the first models? Also, did GE produce other models with the same water line freezing problems after discovering this problem?

I Have a GE Refrigerator and the Evaporator Coil On the Fresh Food side Keeps
Freezing Over, I have Change out the Thermister and that did Not Help, Both Fans
In the fresh food section is Working, What else should I Try?

There is a big patch of frost on the back panel of my GE refrigerator.

I AM TRYING TO ORDER THE HEATING ELEMENT AND THE DIAGRAM SHOWS I HAVE TO BUY THE ENTIRE HOUSING. THE CUSTOMER WAS SHOCKED AT THE PRICE, SO I CALLED A LOCAL SUPPLY HOUSE AND THEY SAID THAT THEY CAN GET THE RESTRING COIL THAT IS MADE BY FRIDGADARE. DOES THIS SOUND CORRECT AND HOW DO YOU MATCH THE ELEMENT? THANKS, TODD FROM NY.

What part do I need to fix this? Think it’s just the element.

When I opened up the evaporator cover it was clearly frosted evenly indicating it had not defrosted in a few weeks. I found a thermistor instead of a defrost terminator. I looked around for a computer board but can’t find one. Can this be a line voltage thermistor to control defrost heater? Unit has a regular timer. I can’t tell anything from the diagrams . Any help will be greatly appreciated Thanks,

hi…i have a ge top load washer …it will not start..dead…i thought maybe the gfi plug…but i plugged it into another source and it still will not start….i did reset the gfi and when i plugged it back in i heard a pop…..not good i know, but i do not know where to start to check it out…..is it fused?? or do you think something else is blown?

this is what i found elsewhere?? just an fyi…not sure what to think…

Cause 1 Thermal Fuse

If the washer overheats, the thermal fuse will blow. If the line fuse blows, the washer won’t start. To determine if the thermal fuse is at fault, use a multimeter to test it for continuity. If the fuse does not have continuity, replace it. In addition, you should investigate and resolve the problem that caused the fuse to blow. If you don’t resolve the underlying issue, the new fuse will blow too.

Cause 2 Main Control Board

The main control board might be defective. However, the main control board is rarely at fault for this symptom. Before replacing the main control board, first check all of the more commonly defective parts.

My cooktop is not heating up.

My GE dryer smells like gas.