Brand: LG

My A/C unit is giving off a chemical smell.

My window air conditioner just blows out warm air.

My air conditioner starts up and then stops after a few minutes.

My LG window air conditioner is not cooling good enough.

How do i replace the belt on this unit.

Drum is off balance or tilted, Drum knocks into cabinet, Will not spin out, Banging noises.

Tub will not spin, Oil leak.

Fans do not run properly, refrigerator runs then shuts off,

PE error code, over filling.

TE2 Error Code.

Short fill, or a water leak on the left side, FE, 1E Error Codes.

LG TOP LOAD WASHER DOES NOT AGITATE IN TEST MODE. BUT CAN HEAR NOISE LIKE ITS AGITATING.

Heater tested bad no continuity or resistance replaced but error won’t go away comes up after the cycle. How can I clear the error code?

Goes into rinse cycle then immediately to drain- does not actually go through the rinse cycle.Not getting dishes clean

We need a tech sheet and wiring diagram for tis range. It is electric with double oven.
Thank you.

The door is not closing properly on my LG refrigerator.

Washer not locking door.

LG dryer DHE error.

Attempted to rewrite control board after compressor replacement only getting failure from jig after attempting rewrite

Pretty sure it’s the evaporator fan motor but can’t find any information on it. Hoping you have it there.

Washer hearing a roaring sound in high speed spin, possible bearings? Library does not have this particular model it does however have a WM2077CW is that a close enough match to be of any help?

I got this torn apart and it seems like the rotor assembly is the main issue here. I don’t do many of them, but was hoping someone there had time to shoot me the necessary information over while I’m here. Didn’t find a repair video but think I can handle it without.

I’ve narrowed this down to a drain pump and drain hose but can’t find the part information. Can I get some help on this one?

Found a lot of frost on the food inside the refrigerator. The fans an compressor seem to be coming on, temps are reading correct, and I’m not finding any mechanical/electrical issues. Am I missing something or is it just a fluke? Charged a service call and told the customer to monitor and let me know.

LG top load washer goes through the wash and 2-3 times spins slowly during wash. Centrifical force sends some water over top. Not sure what to do about this since it is part of the computer software?

Unit not draining. Tried the drain pump and still no drain. 110v coming from both lines (separate readings) to drain pump. Thinking it does not have common. Believe it is the board. Looked on older USB and not their. Anyone have some info on this unit. Thanks in advance