Brand: Whirlpool

I have a top load washer with a mechanical timer that is stuck in a spin cycle. No matter what setting the timer is on it just goes into a spin.

Water under crisp drawers in fresh food section also noticed ice around damper control check for any bulletins there was none also there was no error codes question is why would there be ice around and inside the damper control and what parts may need to be replaced

My Whirlpool washer is leaking.

I just used my dryer yesterday and it worked fine, but today I went to get the load out and it was still damp. Doesn’t seem to be blowing any hot air out. What do you think the problem could be?

Error f6e1 and f3e2 I replaced ccu did not fix wires are fine do you think it is the ui or mcu

The door will not close properly on my Whirlpool dishwasher.

This unit has a hidden bake element. I’m wondering how to remove it. It doesn’t have any screws on the inside to remove the bottom panel to get to it.

How do i change the light bulb in my microwave.

whasher works fine on first load, goes through all the cycles and clothes come out as it should, it fails on second load to spin on high speed, it rinses fine, but it wont go through final spin (high spped), so clothes are too wet, no error codes, diagnostic shows no problems, it keeps trying to balance I guess but it wont go through with it and it times out after too many attempts, I`ve replaced the pump, think it has a faulty pump, shocks looks good as well, need help with this customer machine problem, cant keep replacing parts, any idea?

THANKS MATT. CAN A COMMERCIAL HEAT GUN BE USED TO SPEED UP THE PROCESS?

My Whirlpool washer is displaying an error code

How do I gain access to springs.

One door spring broke, should I replace both?
Access to replace springs. Video etc.
Do I have to watch out for fragile ribbon cable on top panel that can crack.

My Whirlpool washer is making an odd grinding noise.

Hi Folks,
The complaint on this unit is it is not cooling up to par! This unit has an inverter. According to the home owner the condenser has never been cleaned. Clean the condenser and it seemed to lower the temperature. But the inverter continued to beep. It was an inconsistence pattern of on & off and beeping. Not that familiar with inventers and any information will be greatly appreciated.

Thank you,

Jan
Barney’s Appliance
Palm Bay, FL

Can you get me a tech sheet for this unit. It is frosted up and I want to be able to do a forced defrost to check and see if jazz board is bad.

I cannot get any pads to work to enter code

I own a Whirlpool washer that was not running and giving me an error code of “E something”. I unplugged the washer, plugged it back in, worked for a day and did the same thing. I then had a technician out to my home, paid the $70.00 service call, and the technician told me he could not definitively tell me which part was bad. He said the error showed a communication error(?) and it may be my mother board or a motor board or something else(?). Estimate if I needed all parts was almost as much as I spent on the machine. Anyone heard something like this? How can they not know what is wrong with the machine?

Thanks,

Franklin