All Answers » Re: no power a » Comments for "Re: no power a"
  • your advice was to check the power?… sir. also there is not a link supplied.
  • There are three links I supplied. 1) The service manual. 2) Technician diagnostics 3) Parts breakdown. You must be logged in to you account to see these links. https://www.dropbox.com/s/vnutmrgoptbsa02/TechSheet-W10602465-RevB.pdf?dl=0
  • I refreshed the page and the links are there so im a jerk, but also. Still not advice as its impossible to run diagnostics with no power. Its on page 6-2 though for the next person wondering what to do if your machine wont power on. Since the control board clicked like the last one like the sound of a fuse blowing do i need to buy another one ? each time they power on but then initiating a cycle is click. The audible click of a fuse never to turn on again.
  • If you cannot power the unit to put it into the diagnostic mode, you will need to start with the motherboard so you can run it through the diagnostics. That’s what our technician would need to start with.
  • ok im ordering another one, the third. What would cause these to burn out? im just assuming as this will be my third time now ordering and installing for it to break.
  • My best advice is to have a Factory authorized Whirlpool PSP ( Preferred Service provider ) technician come out and install the board. They will check the wiring at the outlet for proper polarity and grounding. They will also check for proper voltage to the board harness. They will also verify it is the board or what is causing the board to short out. The PSP technician has direct access to the Whirlpool technician line where they can get help if there is an issue. They will also warranty the new board if it shorts out after installation.