What should I look for when the lint alarm goes off and kills the dryer? On a separate call, I replaced the belt, pulley, rollers and blower wheel. I Vacuumed Out The unit and was working fine when I left. ????
- Guest asked 10 years ago
- last active 10 years ago
Its fills with water and drain it right away
- Guest asked 10 years ago
- last active 10 years ago
We have a Bosch Dishwasher that goes straight to clean after starting. I won’t bore you with the parts that have been installed. Has anyone ran into this problem that can help?
- Curtis Appliance Repair asked 10 years ago
- last active 10 years ago
The washer shakes pretty violently at the beginning of the spin cycle with clothes in it. Neither sock is broken, none of the block counter balancing pieces are broke or missing, and the springs look good. If you hold the outer tub assembly it will get up to full speed, but vibrates pretty bad. Any ideas? Is there a balanced ring on this unit like some Samsung washers have?
- Guest asked 10 years ago
- last active 10 years ago
My whirlpool dishwasher will not stop running.
- Don Kopecky asked 10 years ago
- last active 10 years ago
My Bosch oven displays “224” error and will not come on.
- James Buchanan asked 10 years ago
- last active 10 years ago
My Bosch dishwasher will not shut off, it continues to run.
- Harley Clark asked 10 years ago
- last active 10 years ago
The door of my washer is locked and I cannot get my laundry or the water out of the unit.
- T&G Appliance Repair asked 10 years ago
- last active 10 years ago
I would like your recommendations for appliances that will last longer than 6 years like most of the brands that are produced today. My customers ask me this question daily. I suggest Speed Queen washers and dryers for laundry products but I’m not sure about the other types of appliances. I’m currently researching Bosch dishwashers. Thank you for any assistance.
- Guest asked 10 years ago
- last active 10 years ago
Microwave turns on for 2 seconds and then turns off. History: I changed out a blown fuse about six months ago but did not know at the time I should have changed the monitor switch. Last time it was dead and now it just turns on for 2 seconds. Any ideas what I should be looking for? Model #HMB5050/01 FD 9007100017 FCC ID ACLAP7A01
- Curtis Appliance Repair asked 10 years ago
- last active 10 years ago
I checked this unit out and only found that there seemed to be a build up of dish soap inside somehow. Assuming customer is soaking or rinsing dishes before loading and it’s migrating into the dishwasher, causing a lot of suds, and not very adequate cleaning cycles. What do you guys normally recommend to clear them? Is there a specific product you use?
- T&G Appliance Repair asked 10 years ago
- last active 10 years ago
Wanted to let you guys know, we’ve had a couple Bosch’s with this complaint, and there’s been nothing wrong after diagnosing. We always check wiring, controls, motor, and heater. No stored error codes, and all safety checks come back ok. Just in case you see any out there, let us know if you actually find a problem!
- Patrick's Appliance Service asked 11 years ago
- last active 11 years ago
This dishwasher was just re-installed after a kitchen remodel. I got called out because it wasn’t draining. I removed the knockout from the disposal the first time thinking that was the issue. Turns out it wasn’t, still having issues. This time I’m getting a bad pump but cannot find the part number anywhere. Somebody there able to look it up for me?
- James Buchanan asked 11 years ago
- last active 11 years ago
Model SHE45M06UC/50
You have to really play with the Power button to get the unit to run. I see where the Off/on switch (#424410) is the likely culprit in my mind, however I seldom work on these enough to become intimately familiar. Am I headed in the right diretion?
- T&G Appliance Repair asked 11 years ago
- last active 11 years ago
I need a new door seal for this model, anyone have time to do the lookup for me? Thanks.
- Harley Clark asked 11 years ago
- last active 11 years ago
Looking at it now and there’s no tech sheet. Thanks.
- Patrick's Appliance Service asked 11 years ago
- last active 11 years ago
if I check water inlet valve for bosh dishwasher and it has continutity to water valve does that mean valve is ok
- Guest asked 11 years ago
- last active 11 years ago
bosch dishwasher has power to touchpad but will not start
- Guest asked 11 years ago
- last active 11 years ago
any tips on taking this dryer apart? Pictures etc.? Can’t seem to find a video.
- Guest asked 11 years ago
- last active 11 years ago
This is a vent less dryer. I have moisture is building up on the back side of the access cover to get to the condenser for cleaning. After 2-3 loads in dryer water will start showing up on floor. Drain pump is working fine. Dryer dries fine.
Anybody have experience with these models or ideas what is causing this? Thanks.
- Gary Williams asked 11 years ago
- last active 11 years ago
Am having a hard time finding the part information for this model. Need an igniter. Any help?
- Harley Clark asked 11 years ago
- last active 11 years ago
I’ve worked on a few of these, and found the limiter open, so I replaced that, but still having issues. What am I missing? There must be something else.
- Sam, Ace Appliance asked 11 years ago
- last active 11 years ago
This customer had been frustrated with her dishes not getting clean and was already pre rinsing, changing soaps, running on high heat, and trying everything she knew how. After arriving it did not take long to find that the spray arms were simply blocked up. After clearing them and running a quick wash to check their use, she was thrilled to have such an easy fix. Always check the basics, one is often the culprit.
- Sam, Ace Appliance asked 11 years ago
- last active 11 years ago
The unit will actually begin to smoke if there’s a heavier load in. Where should I start?
- Guest asked 11 years ago
- last active 11 years ago
I’m having problems with this washer. Model #WFMC1001UC/13. A few months ago I changed out the drain pump on this washer and it worked for a while. When I went this time the washer would not agitate or spin but was draining great. I checked all the wiring, plugged and unplugged all the connections. I tested the washer and then it was running well. Customer stated it was spinning fine for a couple of days. Now complaint is a slow spin. Does anyone know what I should be looking at on this washer? There is a wiring diagram in the washer but I don’t have access to tech support. Any thoughts on this would be appreciated.
- Guest asked 11 years ago
- last active 11 years ago
bosch dishwasher model she6at05ucx/o5
error cod e64
we replaced the control board to no avail
need some assitance please we belieive it could be heating system , also
how do you get this dishwasher into test mode
- Jessie asked 11 years ago
- last active 11 years ago
I have a E01 error code on a Ascenta Dishwasher? any suggestions
- Rany asked 11 years ago
- last active 11 years ago