Hi i need to replace the motor pump but i didnt find a video that shows how to do it thank you
this is the part number: WD19X24705
- applianceusapro asked 4 months ago
- last active 4 months ago
Washer is getting H2O error code washer is not getting cold water water valve has already been replaced solenoid good on Coldwater valve not getting 120 VAC To cold water valve I put washer and diagnostics mode test number seven no cold water comes in Solenoid is not energized not sure if it’s The main PCB board need service manual for washer Hot water valve and other valves are working properly
- Loinest76 asked 5 months ago
- last active 5 months ago
GOOD DAY,
WE HAVE A GE REFRIGERATOR THAT EVERY MONTH OR 2 THE DRAIN LINE FREEZES AND NEEDS TO BE CLEARED. NOW THE REFER SIDE IS TOO COLD AND FREEZING THE VEGES AS WELL AS THE DRAIN TUBE BLOCKED AGAIN.
THANK YOU,
LISA MARTIN
- mastertechca asked 7 months ago
- last active 7 months ago
watched your video, ordered a new capacitor and relay module. Installed new unit same issue. Any other solutions? Refrigerator is only 13 months old.
- Guest asked 1 year ago
- last active 1 year ago
The condenser for this combo needs to be changed due to moisture not being removed. I would like to know if there are any videos for this model as its a never version. Need any tips on assembly for this part.
- GeekJames asked 1 year ago
- last active 1 year ago
Washer give a cancel error on heavy bedding loads. What could be the cause of this?
- GeekJames asked 1 year ago
- last active 1 year ago
How to uninstall water filter housing for this model.
- GeekJames asked 1 year ago
- last active 1 year ago
I need to know how to remove the water filter housing RFID board. Board has a small bolt screw not sure what size tool needed to remove. Any videos, service manual and tools used to perform repair would be greatly appreciated.
- GeekJames asked 1 year ago
- last active 1 year ago
The leak is coming from the water valve into the fridge. I tested the valve: 185 ohms. I also tested it mechanically thinking it would stay open but it didnt. Could this issue be with the ice maker or mainboard. I dont know how common this fail is with this refrigerator.
- Guest asked 1 year ago
- last active 1 year ago
Main control board and inverter board have been replaced Polarity at plugged checked good put washer on normal cycle drain pump kicks on while sensing door does not lock and does not fill with water door lock flashes on display E91 error code
- Loinest76 asked 1 year ago
- last active 1 year ago
Does this unit have a heat exchanger?
My technician said he needs this part due to a Freon restriction. We are not finding a picture on the parts diagram.
My tech said its a capillary tube running from the evaporator that is likely restricted. He was working on a sealed system repair, replacing the compressor and evaporator today.
Please let me know the part number that would be needed.
- gregoryb7 asked 1 year ago
- last active 1 year ago
GE Washer fills with water and starts to turn for about 5 seconds and then stops.
- Guest asked 1 year ago
- last active 1 year ago
In the diagnostics mode the washer in the spin test, the clutch engages ok but the motor does not work. In the agitate test the washer fills but the motor does not work.
I can hear a momentary relay on the board and the motor seems to try to energize for less than 1 second, but nothing else.
- Guest asked 2 years ago
- last active 2 years ago
change the control board /water valve and door latch water presuer is ok but still code is on
- Always1apr asked 2 years ago
- last active 2 years ago
GE Dishwasher Model GDF530PGM0BB
stops mid cycle, all lights flashing, turning power off resets unit to normal,
run thru cycle, repeats problem
- joeski1369 asked 2 years ago
- last active 2 years ago
can you guide me to locate video for Frontload Dryer to access these main control board to replace it.
- Guest asked 2 years ago
- last active 2 years ago
hello, Have a side by side refrigerator and the fresh food section is getting too cold. Freezer seems ok.
- learnnowjim asked 2 years ago
- last active 2 years ago