Brand: KitchenAid

Our ice maker in the bottom freezer does not work. We also hear a crackling/clicking sound. We vacuumed the bottom really well but still no luck.

Kitchen Aid KEMS308 Built in Combo. Microwave wont heat but seemingly works otherwise. Got F1E5 Replace Micro Inverter Error.

Oven was working fine and then we noted that it was in “Preheat” mode with the temperature decreasing. Tried the following, turned off and tried bake then broil, then convection – nothing changed. Opened supply breaker and reclosed. Same “preheat”. Any suggestions before we call the repair service?

My kitchen aid bottom drawer ice maker stopped making ice.

My kitchenaid kfis25xvms6 refrig/freezer went off. Lights inside are on, but the controls lights are off. Can I fix or do I need repair guy?

Model JGS9900 gas range. Oven light will not go out. I have turned the power off for two minutes then turned power back on. This did not help.

I have the diagram for this refrigerator this fridge is not make ice

First call was not cooling. Diagnosis showed fans not running and not getting 120 Volts to inverter. Replaced main board (W10801767). Getting power to inverter but fans still not running and compressor not starting.

Tested board for power to (DC volts) to Compressor (5-6 volts DC) and not getting a reading. Diagnostic mode says fans are running? Compressor windings test good between 6-7 ohms as spec. In diagnostic mode thermistor show a 00. Have I overlooked something? Think a faulty board?

Gas dryer keeps shutting off. I can sometimes get it to complete a full dry after a few start/stop cycles.

When I press ‘start’ either on auto or timed cycles, the dryer will start for about a minute, then stop. Or when the start is pressed, the relay clicks and the drum (I have the top removed) moves about a 1/4 inch. I then press off/then start buttons until the dryer starts (each unsuccessful try the relay clicks and the drum slightly moves). It may take ten off/start button cycles to get it to start again. After which, it may stop after 1-5 minutes or go the whole dry cycle. Sometimes if the start/off button can’t get it to start, then pressing the control button to turn off the lights and then control button to turn on lights and then start after that sometimes works.

I have a Kitchenaid combo microwave and oven … KEMS309bssoo. The microwave runs fine but when the cooking cycle is complete the unit turns off the light and cooking power but the fan continues to run and the bell does not ring. You have to open the door or press the cancel button to get the unit to completely shut off.

I have a kitchen aid dishwasher model number W10476361A with no power at all. Is there a fuse I can replace?

My microwave keeps giving error codes and i dont know what they are.

I have a kitchen aid stove. I tried to remove the oven door without placing the pins needed. It came off but the hinge came with it. how do I fix it?

My fridge Kitchen aid Model ksrs22qfwh01 will not run water or ice thru the door. I also do not know where the water filter is located.

Kitchenaid built in oven microwave combo KEMS308SSS00. Original call was for a F1E5 error inverter. Inspection of inverter the board was clearly burned in several areas. Replaced inverter board and main control board.

When powered back on got F0E6 lost communication error. Checked all fuses and wires between Appliance Manager Board and microwave user interface. Had to replace manager board. After replacement, F1E5 error came back.

What have I overlooked or done incorrect? I would like to get this running for the family. Thank you.

We are the second company to come out to this refrigerator. The first company replaced each board 1 at a time, there are 3 computer boards, and a control panel. So the first guy replaced the 3 computer boards. Now the old ones are back in because they didn’t work. But the customer still has them… We tried replacing the control panel part #: wpw10468941 with the touchpad and power button. When you push on, everything starts up, you can hear the compressor start, but 2 seconds later it stops. After replacing the control panel it is the same problem. Could this by something else besides the electronic components; or should we put the new boards back in with the control panel? Any help would be appreciated.

Some of the buttons on the touchpad of my dishwasher are not responding.

My Kitchenaid microwave is displaying an F7 error code. What does this mean?

Does anyone have a tech sheet for a KitchenAid refrigerator model number KSCS23FVBL01.

Need service manual so I can diagnose and know how to disassemble components to get to evaporator defrost issue. Thank you.

The damper is closed and the freezer temperature is normal. How can i test this control? I need the tech sheet and the service manual.

I removed the old thermistor and measured the resistance in a glass of ice water and got 4.99 omes. I then took the new thermistor and put it in ice water and got 6.3 oms. My question is with the difference of 10 omes is the old thermistor still good.

The dishwasher has power. The Hi-scrub light is on. No switches will activate any function. Nothing comes on when the door is closed.

I also received an answer 1 hour ago which suggest me to go to page 62 of Job aid.
But i cannot find Job aid page of Tab!
Can you help me
Many thank!!!!

I believe it is problem with defrost sensor of timer, but i didnot know where is it?
Do you have any video to show how to un-assemble it?
Thank

Our customer has a kitchenaid gas range which shuts down completely after 45 minutes usage of both oven and surface at the same time. Customer states that in will reset itself anywhere between a couple of hours to a couple of days.

It’s saying stuck key.
I changed the kaypad and I still got the same error.
I changed the control board and I am still getting the same error.
Please advise