I have two of the same models 1st one no water on any cycle. I have 110 volts on temp controller.also sometimes it goes through cycles when water was working. 2nd washer starts agitating when water comes in. but the water level is to low in tub
made sure the pressure hose was clear
- Guest asked 7 years ago
Hello
Most likely both issues are coming from sensing switch. for the one that has no water check and make sure you are not getting 120 to your valve. If you are obviously your valve is bad. otherwise it may be an issue in either timer or load sensing switch. the 2nd appliance is almost definitely your load sensing switch as long as your timer is sending power through your switch.
- AV Repair Help answered 7 years ago
- You must login to reply
Please login first to submit.
