Hi Folks,
This unit is showing the following code: Under the cycle mode there are 3 lights blinking, the first two and the fourth i.e. Smart Auto – Normal – Skip –Delicate! Also, while the door is open the pump is on and pumping out. According to the troubling shooting guide this all relates to high temperature water entering the unit. Although it says nothing about the unit working with the door open. Can someone please point me in the correct direction?
Nothing, but I just looked at the unit late today!
- Guest asked 9 years ago
HI. Yes, the error code for theses 3 blinking lights (smart auto, normal, and delicate) is for a high water temperature error. IF the water temp entering the unit is above 170 deg. it will cause this error. If your incoming water temp. is good, then the most likely part that is bad is the ECS sensor. I attached a link to this part. To replace this part you need to lay the dishwasher on its back or side and remove the two bottom screws for the bottom panel. Now you will have access to the sensor. Twist sensor to remove. You will reuse the o-ring. Let me know if you need any further assistance.
- Brian, Ace Appliance answered 9 years ago
-
Hi Brian, Thank you I will give it a try! Jan Barney’s Appliance
- You must login to reply
HI. Yes, the error code for theses 3 blinking lights (smart auto, normal, and delicate) is for a high water temperature error. IF the water temp entering the unit is above 170 deg. it will cause this error. If your incoming water temp. is good, then the most likely part that is bad is the ECS sensor. I attached a link to this part. To replace this part you need to lay the dishwasher on its back or side and remove the two bottom screws for the bottom panel. Now you will have access to the sensor. Twist sensor to remove. You will reuse the o-ring. Let me know if you need any further assistance.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.
