The unit displays “dispensing water & detergent” then it simply drains the water and says “Ready” like the cycle has completed. What should I be looking at for the cause, my first instinct is the control board however I don’t have a lot of experience on Bosch machines.
Model Number
WFMC6400UC/01
Serial Number
855100082664006791
Request Resource Materials
Service diagnostics guide, Parts manual, Service bulletins, Service pointers, Any available materials
- Guest asked 8 years ago
Hello
See manual links below. If you go to page #20 in the training service manual it will information on the dispensing water & detergent. The service tips are on page #62. Test mode is on page #64. Matt Ace technician
- AV Repair Help answered 8 years ago
-
Matt, I ran the tests on this machine today. There were two error codes, one was high voltage from the motor controller although the motor spin test got the drum spinning at 1150 RPM. The other stored error codes was unbalanced load. I inspected all of the wiring harness’s. I did notice that the dampers had a yellow fluid leaking from them. I am wondering if the dampers are bad if that is causing the unit to shut down before going into the spin cycle and that is why the washer isn’t finishing the cycle.
- You must login to reply
Your Answer
Please login first to submit.
