The washer will without fail make it to the rinse everytime. The in use button is lit however the rinse isn’t, advancing one “tick” will put it in rinse but it does not fill, attempt to wash or advance from there. If you bypass the lid switch and advance it roughly 3 ticks it will start agitating without water or filling. If you advance it far enough (right before final spin) it will spin while adding water.
Tried filling multiple times to see if the coil on the fill valve was broken but making enough of a connection for first fill, tried replacing timer and both pressure switches (with air hoses). Both have failed to fix the problem. The only thing I haven’t tried is having the new timer and switches at the same time. All advice welcome.
- Guest asked 9 years ago
Make sure your cold water fill is working properly. On all rinse cycles no matter what water setting you have it on it will rinse on cold. Also look at your inlet hoses, do you have the kind with a check valve in them ? I have seen the hoses fail mid way through the cycle. The only thing that throws me off is that it still agitated once advanced without filling, that usually means there is a pressure switch issue or timer issue which you have already replaced both. good luck.
- AV Repair Help answered 9 years ago
- You must login to reply
Please login first to submit.
