changed control panel

Hello
This a Canadian model Kenmore. See technician diagnostics link below and run through the diagnostic mode.
To Service Diagnostics Enter Service mode by pressing the “Water”, “Crushed”, and “Cubed” buttons simultaneously for 3 seconds.
The display will show 00 in the FZ temperature display and 00 in the FF temperature display. display shows 00 in each of the FZ and FF displays.LCD Display: Use the up and down buttons on the left to increment the 1’s place to select the desired test. Press any key other than the temp adjust keys to run test.The test mode must be selected within 5 minutes of entering the diagnostic mode or it will time-out, normal refrigerator operation will resume.Once a test mode is selected, the display will show the results of the mode selected. All error codes are listed on the sheet . Matt Ace technician