0 votes
3k views

My dryer will only run for about 30 seconds, and will not run at all if there’s more than one article of clothing in there.

  • Ramon Egbert asked 10 years ago
  • last active 10 years ago
1 vote
3k views

I replaced the clutch and coupler on this washer, and now I’m getting a grinding noise before the spin cycle starts.

  • S&E Appliance Repair asked 10 years ago
  • last active 10 years ago
0 votes
3k views

I’m pretty sure I need to replace the convection fan. I have identified the replacement part online. But I can’t figure out how to get to the back of the oven to get to the convection fan. Do I get there from the inside? Or do I need to take the whole over out of the wall to get at it from the outside? Any videos to help? Thanks.

  • Michael asked 10 years ago
  • last active 10 years ago
0 votes
2k views

I have a GE gss20ietc sidexside and I had it plugged in and open for quite a while taking out the ice maker and auger motor unit because the nut on the auger turning bracket was missing… so after taking those two units out within a couple of days the freezer side was working but the fridge side was not, so I took out the back panel in the freezer like your videos show and yes, almost solid block of ice… BUT one thing was the ground strap was not attached to the panel cover… what does that effect? I tested the heater as per videos show with an ohm meter, it’s good but before I start ordering the defrost thermostat and/or the thermistor, would the ground strap not being clipped on the panel have an effect on the defrosting malfunctioning? TIA

  • Adam Adray asked 10 years ago
  • last active 10 years ago
0 votes
3k views

It was working fine, large load was put in, now it will not spin at all.

  • Conrad asked 10 years ago
  • last active 10 years ago
0 votes
3k views

I would like to know how to put this freezer into the defrost cycle. it was frosted up, so i took it apart and defrosted it. the heater was ok. the defrost thermostat read open even frozen in the ice. after I jiggled the wires a little then it showed good. I replaced it anyway. I would like to put an amp clamp on it while its cold and kick it into defrost to make sure its fixed. i know some of them you open the door a couple of times. I would like to know the sequence to put this one in defrost .

  • ralph harkins asked 10 years ago
  • last active 10 years ago
0 votes
2k views

when I turn on the stove it show me error f 7 and f 9. it don’t let me do nothing. It don’t let me press bake. when i clear those number it come back again. I can not used the oven. I don’t have problem with the top. what i need to do? do i need to reset?

  • sonia roldan asked 10 years ago
  • last active 10 years ago
0 votes
3k views

The washer is making a load noise like a train or plane loud taking off when it goes to final spin…
IF I run an empty load just the rinse spin it seems fine?
Doesnt seem to move on the floor or anything?

Is this a major repair? Clothes come out clean and well rung out… just really loud… If I spin the drum by hand moves smooth and no noise… and all the bar things inside are tight.

Its about 3 yrs old if that.

Thanks

  • Michelle Young asked 10 years ago
  • last active 10 years ago
0 votes
3k views

The machine washing very good…but in the finally cycle the door dont open..it is block…i cup the electric but nothing…i put the button unlocket for 3 ,5 ,10 sec..but nothing…i put out the filter of the pump i clean it but the door dont open is locket with the dress side…a thing is not normal went she come start washing she made a sound in the panel control..just click..click..click…excuse my inglish is not good….

  • Ana Garcia asked 9 years ago
  • last active 9 years ago
0 votes
2k views

video or manual?

  • Ron asked 9 years ago
  • last active 9 years ago
0 votes
2k views

Just watched your video on replacing the upper housing on the dryer door that was causing the dryer to squeak.
Do you recommend putting any type of grease or lubricant on the drum roller where it meets the front piece? Would this help avoid similar problems in the future?

Thanks!

  • Joseph asked 9 years ago
  • last active 9 years ago
0 votes
2k views

Hello,

I found my garage refrigerator/freezer not working with everything defrosting inside. My grandson came over and took off the back plate, said the fan wasn’t running down near the compressor. He thinks he can do the repair himself but I wanted to get a professional opinion with what’s wrong.

Thanks for your help!

  • Thelma A. asked 9 years ago
  • last active 9 years ago
0 votes
2k views

My Side by side will not cool to set temperature, I removed most food about a week ago to see what was going to happen. The freezer temperature has bounced between 21 & 23 Fahrenheit. The back panel is frosted and i can hear the fan running. The Fridge has held between 41-43 Fahrenheit. I have also noticed the water dispenser slowed to a little stream and it has not been making a lot of ice for about a month before the temperatures started dropping. I turned the temperatures on both sides up until the display showed off. So i could hear the water pump kick on when i tried getting water. I have since unplugged the unit now about 12 hours and removed all food and cleaned it.

  • Robert asked 9 years ago
  • last active 9 years ago
0 votes
2k views

Hello, I disconnected the part under the freezer door and tried to run the water. However, water barely comes out and completely stops. There is good water pressure unto the back of the refrigerator. It sounds like it’s trying when I push the lever. Ice works fine. What might be the problem on mine, and how can I fix it? I also replaced the filter with a new one.

Thank You.

If pressure is good coming out of the valve can the problem be the water filter housing. How can I eliminate that as the cause? I see no freezing anywhere.

  • Don asked 9 years ago
  • last active 9 years ago
0 votes
2k views

The back panel of my freezer is frosting over and I got it defrosted enough to test the heater. I’m pretty sure it’s failed but I couldn’t find any videos to help me further. Thanks for anything you can suggest for me.

  • Victor A asked 9 years ago
  • last active 9 years ago
0 votes
3k views

I have a model #PSS26SGPASS that stopped cooling and just makes a loud noise, I think from the freezer side. The loud noise is only present when the doors are shut. The light inside and digits come on but doesn’t show right temperature. At first it showed 555 on each screen, then it would show an error that looked like “Le”, then it would look like it lets me change the temp but then would default to the numbers 78 on each side. Any idea what could be the problem? Thank you!

  • Peter asked 9 years ago
  • last active 9 years ago
0 votes
3k views

How to veriy problem resides is in the touch pad or control panel?

  • Bobby Cook asked 9 years ago
  • last active 9 years ago
0 votes
2k views

can you find a video for our model? Need to know how to replace the board.

  • Holly R asked 9 years ago
  • last active 9 years ago
0 votes
2k views

If the igniter is broken, does the oven still send gas to the burner tube when turned on?  I only ask as it’s not lighting, so I tried to turn it on and light it manually, and apparently there’s no gas coming from the burner tube.  I just want to make sure the igniter is the problem.  Everything else works on the oven – all four top burners and the broiler. which is at the top of the oven.

  • Bill asked 9 years ago
  • last active 9 years ago
0 votes
2k views

Hello,
My fridge has a leak somewhere, it doesn’t seem to be much, but I noticed a small amount of water on the one side and am unsure where it’s coming from. It’s no where near the dispenser area so I was hoping it may just be the drip pan? I’d like to get this taken care of as soon as possible because I had hardwood floors installed last year and am worried this has been going on for some time and I didn’t notice. Help!

  • Zara Tanner asked 9 years ago
  • last active 9 years ago
0 votes
2k views

I was trying to figure out why my dryer won’t turn. I took the panel off and the belt is still on, it hasn’t broken or slipped off, but the drum doesn’t rotate when on. Any thoughts?

  • Ethan Levvy asked 9 years ago
  • last active 9 years ago
0 votes
2k views

refrigerator isnt cooling in fresh food or bottom freezer also no fans ecept for compressor fan. Diagnosis showed freezer defrost sensor. after replacing sensor let run for 24 hours still no cool or fans. checked power board had 5 and 12 volts. replaced main control board. could hear Bottom freezer fan run after holding in light switch for 30 seconds. still no ff fan. Run diagnosis indicated main board was running fan. removed back cover and checked for voltage at fan connection. voltage was 0. also noticed coils were not frosting. assuming bad compressor or possible leak but would this cause the fan to shut down. will go out tomorrow and stick some gauges on it. Any help would be appreciated. Customer fridge has been down for four days

  • phil duncan asked 9 years ago
  • last active 9 years ago
0 votes
3k views

when i turn on any top or oven, it will come on and die out..then i have to leave ignitor on until it comes on and stays very low flame before going to proper setting..

  • GENE asked 9 years ago
  • last active 9 years ago
0 votes
3k views

My washer isn’t spinning out or draining. I checked the lid switch from a video I found but that seems fine. I did do a load of rugs last and am wondering if maybe something got stuck in the pump? Thanks in advance for any help on this!

  • Samantha Kelley asked 9 years ago
  • last active 9 years ago
0 votes
2k views
  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

TURN ON AND IT FIRES UP THEN SLOWLY DIES OUT..CAN NOT LIGHT…

  • GENE asked 9 years ago
  • last active 9 years ago
Showing 1 - 30 of 2k results