Brand: KitchenAid

5 DOOR REFRIGERATOR HERE AND IS GIVING PO CODE. THE MAIN BOARD AND THE POWER CONTROL BOARD BOTH HAVE BEEN CHANGED. THE COMPRESSOR CYCLES OF AND ON ABOUT EVERY 30 SECONDS TO A MINUTE. THERE IS FROST BUILD UP IN THE MIDDLE SECTION AND SOME IN THE FREEZER SECTION. ALL WIRES IN THE LEFT DOOR HAVE BEEN SPLICED. SOMEONE TOOK THE TECH SHEET, SO I CANNOT GET INTO DIAGNOSTIC MODE. ANY HELP ON THIS ONE WOULD BE WONDERFUL.

The machine is cleaned regularly and still looks like new although over 10 years old but recently it has been making a churning noise from the pump and noticed the water reservoir not filling all the way or not filling. 8 have turn off and on after resting it for 30 minutes and it will make another sheet but 5he same thing. The water flow each time I start the machine is strong as always but can’t figure out the problem. I’m pretty handy and have replaced parts over the years but this one has me stumped and nothing is on the internet with these systoms.

I know the ice maker is bad on this unit, the question I have is, I know these units used to be bad about icing up at the back of the air chute from freezer, causing condensation the freezing over. Do you know what the kit part number is for the updated foam seals and the rest of the kit?

the top rack left front mount that goes into the rail is broken. we need to know how to replace

Already replaced the temperature sensors but one thing we noticed was that oven was slightly warm without any use. Replaced the temperature sensors on both upper and lower oven but the customer called back saying it’s doing it again after like two months I’m starting to suspect it’s the control board?

I can’t figure out how to access the refrigerator evaporator, need a service manual.

The refrigerator side is not keeping cool enough. The door just falls open and appears to have no suction. Normally on this unit the interior wall is warm but it is not warm on this one.

do you have a video on removing the ice maker

Kitchen aide Bottom freezer. French doors. The refrigerator is cooling properly, but the freezer is not getting colder than 70 degrees. This is a dual evaporator model. We tried running diagnostics but could only get to step 4. Do you have more information on how to test this model. We are suspecting that the freezer evaporator switching valve may have an issue Is there a test to check this?

KITCHENAID MICROWAVE RAN DIAGNOSTICS ERROR F1 E5 SCREEN SAYS REPLACE MICROWAVE INVERTER. I REPLACED INVERTER AND MICROWAVE CONTINUES TO GIVE SAME ERROR CODE. I CHECKED SOME OTHER POSTS AND THEY INDICATED THAT HE APPLIANCE MANAGER IS THE CULPRIT. I REPLACED THE APPLIANCE MANAGER DIAGNOSTICS SAYS STILL SAME ISSUE F1 E5 CAN YOU TELL ME WHERE TO GO FROM HERE. I TRIED TO RESET ERROR BY GOING INTO DIAGNOSTICS OFF OFF START THEN 6 THEN 6 AGAIN THEN PUSH START AND THAT IS SUPPOSED TO RESET BUT ONLY BEEPS.
WHAT OTHER CHECKS CAN I DO.

KitchenAid refrigerator not cooling in fresh food section. Looks like it’s a defrost issue as freezer back wall is frosted up. Looking for tech assist on how to force it to defrost, etc. Also, what are the parts for desfrosting other than heater? Curious what this fridge has for defrost, ie sensor, thermistor, etc.

Above items not working. Are they connected. Circuit wise? Please help with troubleshooting. Put it into diagnostic mode and it shows up with replace filter sign on first step. When I advance it to next step, it says order filter. When I check filter, it says it’s hundred percent. It’s been a big mystery. Thank you.

Customer called for service on his icemaker…. after replacing the water valve to no avail, I found that the compartment in the ceiling with the icemaker and fan assembly was around 25-28°F, which I knew was too warm for the icemaker to operate. Yet, the bottom freezer compartment is well cold enough, in the single digits (2-5°F).

My Kitchenaid DW will not cycle. The control panel lights up, but I cannot get the Start/Resume button to stop blinking. I think there may be an issue with the latch. The model is KUDP02FRWH3…it is pretty old, about 20 years.

My KitchenAid dishwasher has an intermittent problem. Sometimes the buttons will not respond. If I flip the circuit breaker for the dishwasher the buttons come back on. This happens 2-3 times a week, then won’t for ~3 weeks, then happens again. Otherwise operation is fine.

Trying to find out how to disassemble the bottom crisper to get to the dual water valve.

Hello, we’ve been having issues with our ice maker , not dispensing ice. we have changed the motor yet it still doesn’t work. what can we do?

My KitchenAid Kuds35fxss9 control panel has become unresponsive.

My kitchen aid dishwasher is flashing “F1” & “E2” not sure what it means or what to do.

Hi my kitchenaid microwave went completely dead on me after the door mechanism got stuck. I was able to release it no problem and the door opens and closes perfectly but the unit is dead as can be. Checked the breaker and it’s A-Ok.

My Kitchenaid fridge’s control panel won’t turn on. If I press the On/Off button, it flickers briefly, but then goes out again.

My KitchenAid microwave convection oven turns on, lights up but carousel does not turn and food doesn’t cook. was working fine until i used what i thought was the timer for 60 minutes – turned out it was on for that length of time.