I need a service manual. I have water to the back where the line goes into the filter (I suppose it’s to the filter)The Ice maker fills ok but there is not water to the dispenser. When I push the paddle I can hear the valve actuate but, Nothing. Is there a secondary valve some where? I couldn’t find it in the door . If so where is it?
- Guest asked 4 years ago
- last active 4 years ago
Hello, Please read the Question carefully. This top load washer is about 5yrs old. Goes off balance almost every load. The Ue code will show. Start a cycle, it fills ,agitates, then after a few minutes starts spinning in one direction with water in the tub. Bang, Bang, Bang. Stops and starts agitating again. Bangs with clothes or no clothes. When it is in a spin cycle, after a while UE shows up even with no clothes in it. The tub bearings are good. The tub nut is tight. The rotor is not loose. Can hear water in the balance ring. Washer is level. Had one do this in the past, I changed the suspension rods. Still did the same thing. I asked this same question 2Yrs ago. suggested change control & rotor before 2014, and rotor only after 2014. This doesnt sound right for the problem I’m having. Then look at a video where you use rubber bands. Please, I need real help. This is a real common problem, I have seen 10 LG washers doing this. I dont know exactly what is causing the problem. The washer worked ok for 5yrs. Customer is not loading it improperly. When you come up with a solution please explain how or why this solution will fix the problem. Thank You, Jim
- learnnowjim asked 4 years ago
- last active 4 years ago
Without any clothes running a spin it will show this error.
None of the usual problems are causing this. I need a tech sheet and service manual and if off the top of your head what have you experienced about this problem?
- Guest asked 4 years ago
- last active 4 years ago
The water valve for this refrigerator is leaking. The problem is that the valve LG is saying that it needs is a MJX41178908, the mounting is perfect but this valve is a single solenoid valve. The original vale is a dual solenoid valve but they give no instructions to convert. I wanted to see if you have run into something like this before, get advice, or see if there is any instructions on this. There is another valve MJX41869202. THe valve that is in there is way different than both. Amy advice or research would be greatly appreciated.
- mastertechca asked 4 years ago
- last active 4 years ago
I need a service manual and any technical advice.
Is this the hall sensor?
- Guest asked 4 years ago
- last active 4 years ago
- Guest asked 5 years ago
- last active 5 years ago
Theres no error codes
- Guest asked 5 years ago
- last active 5 years ago
- Refrigerator is not cooling. It looked like compressor was not getting power.
- So, I replaced main controller board (EBR673480) and inverter (ABQ73004302).
- Now every component is working, still no cooling
- Compressor is drawing 0.3Amp current
- Condenser fan is working
- Evaporator fan is working, I can feel the air coming out in the freezer (No air flow in upper part)
What may be the problem?
- Guest asked 5 years ago
- last active 5 years ago
Left rail stuck.. freezer door will not open. Looks like rail is lock in mid Position
- Guest asked 5 years ago
- last active 5 years ago
I know this is a long shot, but I have a customer that says the washer makes a slight squeaking noise at the start of the spin cycle and the end of the spin cycle. I have been there 2 times and have yet to heat this squeak. I really don’t know where to start, other than rotor / stator. Tub supports are lubed. Please if you have any suggestions pass them on. I am going back out tomorrow for the 3rd time.
- Guest asked 5 years ago
- last active 5 years ago
We need a tech sheet and wiring diagram for tis range. It is electric with double oven.
Thank you.
- Guest asked 5 years ago
- last active 5 years ago
The wiring diagram is missing on this unit and we are wanting to see what board powers the cooktop portion of the Range. Any chance of finding the wiring diagram for this unit? Issue is front left burner intermittently turning off.
- Guest asked 5 years ago
- last active 5 years ago
LG getting an IE error code. the unit will stop about 17 minutes left to the cycle and there is water in the unit.
if I put it on spin it will drain out the rest of the water. the error code appeared only twice, however, the rest of the times the unit will just stop mid-cycle and there is water in the tub
- Guest asked 5 years ago
- last active 5 years ago
The water line part number AJR56656503 is cracked inside the back of the cabinet. It is part #616G on the diagram. I would like some help on how to replace it. thanks
- Guest asked 5 years ago
- last active 5 years ago
Hello, I have a scratch and dent dryer that is new it only works on time dry. when you put it on normal it works but just does not flame up?
- Guest asked 5 years ago
- last active 5 years ago
need to made go into test mode or show error codes
- Guest asked 5 years ago
- last active 5 years ago
Any solutions known to the tones or alarms described above?
- Guest asked 5 years ago
- last active 5 years ago
Hello, we just started in the scratch and dent repair so we are a little new. the water does not go in the tray to make ice any thoughts?
- Guest asked 5 years ago
- last active 5 years ago
Do you have a video, or service manual, on how to remove and install this hinged door?
- Guest asked 5 years ago
- last active 5 years ago
I have a dishwasher that powers on and when you hit start it counts down lines go across the screen it sits for around 1 min and powers down any thoughts?
- Guest asked 5 years ago
- last active 5 years ago
The fridge was not cooling I had an appliance tech come and test it he told me the compressor was bad as was the PCB. I replaced the PCB and the compressor. The old compressor had the two posts on top and one on bottom. I ordered my new compressor from sears with the part number and the one they sent me is the same part number but the posts are opposite one on top two on bottom. When I connected everything the condensor fan kicks on but nothing from the compressor no clicking nothing. Is the difference in the compressor causing the problem?
- Guest asked 5 years ago
- last active 5 years ago
Need a service manual and instruction how to test lid lock switch.
- Guest asked 5 years ago
- last active 5 years ago
I need any advice and Tech sheet
- Guest asked 5 years ago
- last active 5 years ago
I am looking for a service manual or wiring diagram for this gas dryer that has the issue of the motor constantly running the only way it will stop us to unplug or to open the door I am suspecting the motor relay stuck in the closed position
- Guest asked 5 years ago
- last active 5 years ago
I changed the freezer grille assembly (with ice fan included)(AEB73785615). On this particular part, it had what looked like to be a heater on the ice fan assembly. What stumped me, was there wasn’t anyway or anywhere to plug this part up. What am I missing here, as I know these LG units are notorious for freezing around that fan? At the moment I just removed the heater and installed the new grille.
- Guest asked 5 years ago
- last active 5 years ago
I need a tech sheet and any matetials or videos and advice on this problem.
- Guest asked 5 years ago
- last active 5 years ago
Goes into rinse cycle then immediately to drain- does not actually go through the rinse cycle.Not getting dishes clean
- Guest asked 5 years ago
- last active 5 years ago
Water dispenser works fine. Replaced dual valve in door, power goes to valve but no water out of it to ice maker. Checked pilot valve in rear, has power to it for water dispenser, however no power going to pilot valve when ice maker tries to fill.
- Guest asked 5 years ago
- last active 5 years ago
