Brand: Maytag

F25 error code even after replacing m. Board

I’ve cleaned out the drain as well as the pump I did find some debris in the drain I’ve cleaned everything and I am still getting this message

Selected light load, cold wash/cold rinse. Cycle stopped after rinse. Machine went to OFF. Restarted manually at last rinse/spin cycle to get water out; noticed water in washer was very warm. Door locked properly, machine agitated, rinse began but then did not turn off. Shut machine off, water continued to come in from hot water only. Unplugging machine worked; water stopped coming in.

THE UNIT HAS 3 ERROR CODES; SUD, F21 AND F35. THERE ISN’T ANY SOAP IN THE MACHINE. THE PUMP IS WORKING AND THERE ARE NO BLOCKAGES. THE TUBE TO THE ANALOG PRESSURE SWITCH IS OPEN.

I GUESS I NEED TO KNOW HOW TO TEST THE ANALOG PRESSURE SWITCH, IF POSSIBLE. ANY OTHER IDEAS WOULD BE APPRECIATED. ALSO IS THERE ANYWAY TO CLEAR ERROR HISTORY ON THIS UNIT?
THERE WAS A MENTION OF CLEARING VENT HOSE, WHERE MIGHT THAT BE, AS I DIDN’T THINK ANY HOSES I COULD SEE WERE VENT HOSES.

THANKS

i changed the evap fan and it still will not go on.
i know there is power to it.

The unit was full of water and would not respond when I set it in the spin drain cycle. It would not energize the pump and would finally lock the door after about 2 minutes.

the board lights up
i can select the option i want and when i press start nothing happens i see it trying to move to the cycle but nothing happens.
i did check the door switch and thermal fuse and all is good.
can it be the board?

Washer started leaking recently, research indicates that the most common cause is the bellows. On older washers, many times the culprit was the seal on the pump where it connects to motor. How can I tell for sure that it is the bellows and not some other part.
I already replaced the hot and cold faucets which I initially thought was the problem but not the box is bone dry including the drain hose inlet.
Still, a lot of water on the floor which seems to be coming out from under the washer on the left side.
I’ve already bought the bellows from your affiliate source but before I waste the $150 and can’t get it back, I’d like to be sure that the bellows is the source of the problem.
not sure what year the machine is as I bought it from a friend who was moving. Serial number is HLW4045088

Also wondering why the bleach dispenser sometimes does not fully drain. I’ve ruined several pieces of clothing, thinking that what was in the dispenser was water, rather than bleach.

If I only get one question, then the first one is the most important. Thank.

A check for 115 volts from The Wire to the timer by disconnecting the lid switch and I am getting a hundred fifteen volts when it’s on spin will it switch itself some places are giving me continuity some places aren’t please advise

When we turn on the washer water comes running out from the siphon brake.
the clamps are all on tight

This into will tumble briefly while filling but that is all the movement you get.if you pause the cycle and try to restart the control just beeps at you until you unplug and restart, also the unit will not unlock the door any other way than to unplug and wait. I also am looking for tech sheet for this unit

it dose drain and spin but when it fills with water it leaks out from the bottom of the front door

Ice maker isn’t making ice?

replaced control part w108900094 and part wp12999401b and that did not solve problem can you help ?

Not washing clothes?

Steps on programing board.

do you have a video on how to replace the drain pump. may tag front load