Brand: Whirlpool

I did not hear any clicking from the igniter I suspect that may be electronic spark module however the bake igniter works perfectly

When we turn on the washer water comes running out from the siphon brake.
the clamps are all on tight

Evaporator and condenser fan motors running compressor running outer loop in front of door hot off and on open door light does not come on press button on control and light comes on but than goes out I suspect board is bad need video on how to replace the board and to know if I should check anything else compressor has a inverter board and when I open door switch what should my switch read when I check for continuity I do want to replace board without first being able to access the control and check board out I dont believe this has a main control board in the back correct me if am wrong

Hello
I’m working on whirlpool d.w, start light and cancel light flashing rapidity. I tried hard rest but nothing happened. I also tried putting into diagnose mode but not working either.

I have a combo / stackable washer dryer from Whirlpool. The customer complaint is that it doesn’t shut off. She tried all 3 cycles and it won’t turn off.

Is there a way to check / test the timer? To make sure it’s not anything else. I don’t want to spend the money for a timer ONLY to find out that it could be something else.

What is knob or dial under freezer door in kick plate for and do you adjust it? Temp controls in fridge .

I am working on a Whirlpool WFW8400TW02. HLW 19 Initially I found long drain errors stored and the pump not running looking for power to it I found open neutral feed diagnosed CCU failure pump ohm’s 14 door also locked. Replaced ccu door remains locked no errors pump ran breifly with new ccu unplugged mi3 connector still no errors shown door locks no motor function throughout after , I replaced two ccu boards still same has anyone seen this?
Lock ohm’s 60 both ways
Interlock SW is closed
Pump 13 ohms
Polarity correct
Any suggestions would be greatly appreciated

Per the customer he already replaced the icemaker and saddle valve himself but is still having issues. What else should I have on hand to get this fixed and working again for him? We don’t do many icemaker repairs and I’m trying to do him a favor by helping him out.

Lid is locked and cannot get it to reset. Got there and found the drain pump seized and not working. Do you have this drain pump?

I am looking for fault or error codes for the models below. Thanks in advance for your help

WRF989SDAB – Black
WRF989SDAE – Black with Silver Handle
WRF989SDAF – Mono Satina Steel
WRF989SDAH – White with Silver Handle
WRF989SDAM – Stainless Steel
WRF989SDAW – White

There is ice build up in the bottom of my whirlpool refrigerator

My whirlpool dryer is not tumbling.

My Whirlpool dishwasher is not draining and the cycles seem to be taking too long.

I am working on a kitchen aid refrigerator model that has no water and no ice.
Wiring diagram is missing. Dispenser panel switches work ok but no 120 volts to valve. Any help is appreciated

The lid on my Whirlpool washer will not lock.

My Whirlpool refrigerator is leaking water.

My Frigidaire range is not getting up to or maintaining the proper temperature

My Whirlpool dishwasher is not draining all the way out.

My Whirlpool refrigerator is leaking.